摘要
利用力学性能、电学性能测试 ,金相、电镜观察及电子衍射分析研究了不同形变热处理条件下Cu 1.5Ni 0 .2 7Si合金性能与显微组织的关系。结果表明 :该合金经 85 0℃快速热轧淬火后表现为明显的变形组织 ,无动态再结晶现象 ,只有极少量的第二相析出。4 5 0℃时效 4h处理后 ,其显微硬度达到峰值 (HV15 8) ,相对电导率达 4 4 % (IACS)。δ Ni2 Si析出相粒子的平均尺寸约为 15nm ,间距约为 10～ 30nm ,与铜基体存在确定的位向关系 :(110 ) m∥ (2 11) ppt,[110 ]m∥ [32 4 ]ppt。合金经 80 %的冷轧变形后 ,σb、σ0 .2 、显微硬度、延伸率和相对电导率 (IACS)分别达 5 78MPa、5 73MPa、HV 173、3%和 4 1.5 %。合金的强化机制为Orowan位错绕过机制。
The microstructures and properties of Cu-1.5Ni-0.27Si alloy under different heat treatment conditions were examined by mechanical and electrical properties measurement, optical and transmission electron microscopes observation. The results show that the obvious deformation textures present in this alloy after rapid hot-rolling and water quenching without a marked dynamic recrystallization. And only few precipitate phases can be observed by using transmission electron microscope (TEM). The microhardness (HV) and relative electrical conductivity reach HV 158 (peak value) and 44%(IACS) respectively followed by aged at 450 ℃ for 4 h. There exists a clear orientation relationship between the precipitate δ-Ni_2Si and copper matrix as follows: (110)_m∥(211)_(ppt),_m ∥_(ppt). After being cold rolled with 80% deformation, its σ_b, σ_(0.2), HV, elongation and relative electrical conductivity(IACS)reach 578 MPa, 573 MPa, HV 173, 3% and 41.5%, respectively. The alloy is strengthened by the precipitate δ-Ni_2Si through Orowan looping mechanism.
出处
《中国有色金属学报》
EI
CAS
CSCD
北大核心
2003年第5期1061-1066,共6页
The Chinese Journal of Nonferrous Metals
关键词
铜合金
形变热处理
性能
显微组织
Cu-1.5Ni-0.27Sialloy
property
microstructure
thermomechanical treatment
