期刊文献+

索氏提取-反相高效液相色谱法测定人工晶状体中甲基丙烯酸甲酯单体残留量 被引量:9

RP-HPLC Determination of Residual Amount of Methyl Methacrylate Monomers in Intraocular lens by Soxhlet′s Extraction
在线阅读 下载PDF
导出
摘要 应用反相高效液相色谱法测定了由聚甲基丙烯酸甲酯(PMMA)或由亲水性丙烯酸酯(HMA)作原材料制成的人工晶状体(IOL)中甲基丙烯酸甲酯单体(MMA)的残留量。采用索氏提取法分离MMA,选用异丙醇作为PMMA制成的IOL样品的提取溶剂,而选用乙腈作为HMA制成的IOL样品的提取溶剂。萃取液采用旋转蒸发仪浓缩,浓缩液经Waters C18色谱柱分离,用乙腈-水(30+70)溶液洗脱,在波长220nm处进行紫外检测。MMA的质量浓度在0.33~42.08mg.L-1范围内与峰面积呈线性关系,方法的检出限(3S/N)为0.02mg.L-1。日内和日间相对标准偏差(n=6)分别为0.72%和0.92%,回收率在98.5%~106.2%之间。 RP-HPLC was applied to the determination of residual amount of methyl methacrylate(MMA) monomer in intraocular lens(IOL) made of polymethyl methacrylate(PMMA) or made of hydrophilic methacrylate(HMA).Soxhlet′s extraction was used for the separation of MMA monomer;isopropanol was selected as extraction solvent for IOL sample of PMMA and acetonitrile was selected as extraction solvent for IOL sample of HMA.The extracts were concentrated by rotary evaporator,and the concentrate was used for RP-HPLC analysis.Waters C18 column was used as stationary phase and acetonitrile-H2O mixture(30+70) was used as mobile phase in the separation.Ultraviolet detector at 220 nm was adopted in the determination.Linear relationship between values of peak area and mass concentration of MMA was obtained in the range of 0.33-42.08 mg·L-1 with detection limit(3S/N) 0.02 mg·L-1.Values of recovery were ranged from 98.5% to 106.2%,and RSD′s(n=6) of intra-day and inter-day found were 0.72% and 0.92% respectively.
出处 《理化检验(化学分册)》 CAS CSCD 北大核心 2011年第11期1256-1258,共3页 Physical Testing and Chemical Analysis(Part B:Chemical Analysis)
关键词 反相高效液相色谱 索氏提取 人工晶状体 甲基丙烯酸甲酯 单体 RP-HPLC Soxhlet′s extraction Intraocular lens Methyl methacrylate Monomers
  • 相关文献

参考文献4

二级参考文献17

  • 1Shim JS, Watts DC. Residual monomer concentrations in denture -base acrylic resin after an additional, soft- liner, heat- cure cycle [J]. Dent. Mater, 1999, 15:296-300
  • 2Urban VM, Cass QB, Oliveira RV, et al. Development and application of methods for determination of residual monomer in dental acrylic resins using high performance liquid chromatography [J]. Biomed Chromatogr, 2006, 20:369-376
  • 3Paulo Meneghett. Syed Qutubuddin. Sythesis of Poly (methyl methacrylate ) Nanocomposites via Emulsion Polymerization Using a Zwitterionic Surfactant [J]. Langmuir, 2004, 20:3424 - 3430
  • 4Zhang W, Shen X, Li Y, et al. Sythesis and characterization of poly(methyl methacrylate)/OMMT nanocomposites by X -ray irradiation polymerization[ J ]. Radioation Physics and Chemistry, 2003, 67:651 -656
  • 5Li Y, Zhao B, Xie S, et al. Synthesis and properties of poly ( methyl methacrylate )/montmorillonite ( PMMA/MMT ) nanocomposites [ J ]. Polymer int, 2003, 52:892 - 898
  • 6Vallitu PK, Lasslia VP, Lappalainen R. Transevers strength and fatigue of denture acrylic - glass fibre composite [ J ]. Dent Mater, 1994, 10:116-121
  • 7Vallitu PK. Comparison of the in vitro fatigue resistance of acrylic resin removeable partial denture reinforce with continous glass fibers or metal wires [J]. J prosthodontics, 1996, 5:115 - 121
  • 8Takahito kanie, Hiroyuki Arikawa, Koichi Fujii, et al. Flexural properties of denture base polymers reinforced with a glass cloth - urethane polymer composite [J]. Dent Mater, 2004, 20:709-716
  • 9Teraoka F, Nakagawa M, Takahashi J. Adaptation of acrylic dentures reinforced with metal wire [J]. J oral Rehabil, 2001, 28:937 - 942
  • 10Braden M, Davy KWM, Parker S, et al. Denture base poly (methyl methacrylate) reinforced with ultra - high modulus polyethylene fibres [J]. Br Dent J, 1988, 164:109 - 113

共引文献15

同被引文献102

引证文献9

二级引证文献66

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部