摘要
通过纯铝板的电磁自由成形实验 ,得出了工件最大变形高度与成形电压呈线性关系的结论 ,列出了线性方程。通过对变形曲线的分析 ,提出用二次多项式曲线来近似工件的变形曲线。这样 ,在变形高度与成形电压的线性方程已知的情况下 ,成形电压确定 ,工件的近似变形曲线就可以确定。
Through the experiments of the aluminum sheet electromagnetic free forming, the conclusion that the maximum deformation height of the work piece is of linear with the forming voltage can be obtained, and the corresponding linear equations are also listed.By analysis of the deformation curves, it is proposed that the deformation curve of the work piece can be expressed approximately by a 2-order polynomial curve. Then, when the linear equation of the deformation height and the forming voltage has been known, andthe forming voltage has also been determined, the approximate deformation curve of the work piece can be obtained.
出处
《中国机械工程》
EI
CAS
CSCD
北大核心
2003年第19期1628-1631,共4页
China Mechanical Engineering
基金
北京市先进制造技术重点实验室开放课题基金资助项目 (KP0 10 0 2 0 0 2 0 1)
关键词
电磁成形
变形高度
成形电压
变形曲线
铝板
electromagnetic forming deformation height forming voltage deformation curve
