摘要
目的对压丸机喷体滑板进行改造,解决软胶囊开机过程中产品装量差异大的问题,提升开机效率,稳定产品质量。方法喷体在注料状态下滑板和底座间的注料孔错位,在外气缸与滑板处加装2.5 mm厚的垫圈,使滑板整体往外拉2.5mm,把垫圈与设备部件加工成一个整体,避克由人员安装误差造成的差异。结果通过改造,使注料孔通过率由原来的40%提升到100%,开机调试时间由原来的平均3 h降为0.5 h,产品装量差异由原来的±20 mg降为±5 mg。结论改造后压丸机更适合软胶囊产品的生产,产品质量更加稳定,开机效率更高。
Objective The spray-plate slide of the pelletizing machine was modified to solve the problem of large difference in product loading during the startup of soft capsule, so as to improve start-up efficiency and stabilize product quality. Methods The injection body was in the position of the feeding hole between the skateboard and the base under the feeding state. A 2.5 mm thick washer was added to the outer cylinder and the skateboard to make the skateboard pull out 2.5 mm as a whole. The washer and equipment parts were processed into a whole to avoid the difference caused by personnel installation error. Results Through modification, the charging hole penetration rate was increased from 40% to 100%, the time of starting and debugging was reduced from the original average 3 h to 0.5 h, and the product loading difference was reduced from ±20 mg to ±5 mg. Conclusion After transformation, the press is more suitable for the production of soft capsule products, the product quality is more stable, and the startup efficiency is higher.
作者
肖良军
黄袁明
方继新
李太适
XIAO Liang-Jun;HUANG Yuan-Ming;FANG Ji-Xin;LI Tai-Shi(By-Health Co.,Ltd.,Zhuhai 519040,China)
出处
《食品安全质量检测学报》
CAS
2018年第22期6035-6038,共4页
Journal of Food Safety and Quality
关键词
喷体滑板
软胶囊
注料孔
spray body skateboard
soft capsule
note hole
