摘要
通过定量金相分析显微疏松含量的方法,研究了图片亮度、对比度、放大倍数等测量参数对某铸造低压涡轮叶片中显微疏松含量测量结果的影响规律。在正常亮度和对比度附近范围内波动时,对手动分割后显微疏松测量值影响不大;图片亮度和对比度过高或过低时,显微疏松的测量值产生偏离。测量面积相同时,不同的放大倍数所测得的平均显微疏松面积百分比测量值相差不大。采取测量区域中最严重视场的显微疏松含量作为显微疏松测量值时,放大倍数越大,显微疏松面积百分比越大。
The effect of measurement parameters on micro-porosity assessment results in a low pressure turbine blade was studied by metallographic quantitative method. The change of micro-porosity measured values with brightness, contrast and magnification was studied. Brightness and contrast change in normal range has little ＇effect on micro-porosity measured values when metallography is segmented manually. Metallography of micro-porosity with low definition, or over high brightness or contrast, or over low brightness or contrast, will bring great error in measurement values of micro-porosity. Average micro-porosity values measured in different magnification metallography are close in the same field size of view. Micro-porosity measured values of the same field size of view increase with magnification of metallography when measured by the worst single field of view method.
出处
《铸造技术》
北大核心
2017年第8期2053-2059,共7页
Foundry Technology
基金
国家自然科学基金资助项目(51301181)
天津市应用基础与前沿技术研究计划(15JCZDJC39700)
天津市科技特派员项目(16JCTPJC49500)
天津市高等学校创新团队培养计划项目(TD12-5043)
天津职业技术师范大学校级科研项目(KJ1709)
关键词
显微疏松
定量金相
测量参数
micro-porosity
metallographic quantitative
measurement parameter
