摘要
采用统计分析方法,通过孔径分布、气孔最邻近距离和局部气孔率定量分析定向凝固藕状多孔镁横截面上的气孔分布特征,并在此基础上分析气压对藕状多孔镁气孔分布的作用规律。结果表明:纯氢条件下气压越高,孔尺寸分布越趋于一致、孔位置和气孔结构单元分布越均匀;氢气分压一定,选择合适的氩气分压可使熔体共晶凝固时,孔尺寸、孔位置和气孔结构单元的分布最均匀。
The characteristic of pore distribution on cross section of lotus-type porous magnesium fabricated by unidirectional solidification was quantitatively studied with the pore size distribution, nearest-neighbour distance of pores, and local porosity by use of statistic analysis methods. On the basis of this analysis, the influences of gas component and pressure on pore distribution were then studied. The results show that at pure hydrogen atmosphere, the uniformity of pore size, spatial distribution of pores and pore-cells increases with hydrogen pressure. While at a constant hydrogen pressure, the uniformity of pore size, spatial distribution of pores and pore-cells is the best when the melt solidifies at eutectic point.
出处
《中国有色金属学报》
EI
CAS
CSCD
北大核心
2007年第2期200-206,共7页
The Chinese Journal of Nonferrous Metals
基金
国家自然科学基金资助项目(50404002)
国家重点基础研究发展计划前期研究专项资助项目(2004CCA05100)
关键词
多孔镁金属
定向凝固
藕状结构
空间分布
porous Mg metal
unidirectional solidification
lotus-type structure
spatial distribution
