摘要
开发一套基于PC机的内燃机燃烧测试分析系统,并对气缸压力的采集,数据的匀化、光顺处理,动态上止点位置的确定等做介绍。利用测量的气缸压力曲线和能量守恒原理,在LabVIEW软件平台上编写出内燃机燃烧放热率计算程序,研究主要经验参数对放热率及缸内平均温度的影响。结果表明:采用Woschni传热公式计算的放热率曲线值高于采用Eichelberg传热公式和Sitkei传热公式计算的放热率曲线值。扫气系数φs的变化对气缸内平均温度有显著影响,φs=0.99时的缸内平均温度明显高于φs=0.95时的缸内平均温度,两者最高温度相差81.4 K。
A combustion test and analysis system based on PC was developed including instruments design and software compiling. The acquisition of cylinder pressure, data homogenization processing, data smoothing processing, as well as the determination of dynamic TDC position were all introduced in this study. Based on the test data of cylinder pressure and energy conservation principle, the heat release rate was calculated by a program in LabVIEW software, and the influences of some parameters on heat release rate and in-cylinder instantaneous average temperature were investigated. The results showed that heat release rate calculated with Woschni heat transfer equation was higher than that with Eichelberg heat transfer equation and Sitkei heat transfer equation. The change of scavenging coefficient φs had a significant effect on average temperature in cylinder. When φs=0.99, the cylinder average temperature was significantly higher than that in φs=0.95 and the maximum temperature difference was 81.4 K.
出处
《中国测试》
CAS
北大核心
2014年第1期83-87,共5页
China Measurement & Test
基金
国家自然科学基金项目(51076033)
广西大学实验室建设与实验教学改革项目(20110107)
关键词
内燃机
放热率
示功图
燃烧分析
internal combustion engine
heat release rate
indicator diagram
combustion analysis
