摘要
目的:建立鲜地黄提取物中3种原型入血成分的含量测定方法。方法:以血清药物化学方法追踪确定地黄原型入血成分;采用Inertsil ODS-SP C18色谱柱(4.6 mm×250 mm,5μm),柱温35℃;乙腈-水为流动相,流速1 mL.min-1,检测波长203 nm的HPLC方法,测定鲜地黄提取物中原型入血成分的含量。结果:在大鼠含药血清中发现梓醇、地黄苷D和益母草苷均以原型入血;此3种成分梓醇、地黄苷D、益母草苷线性范围分别为0.32~1.60μg(r=0.999 6),0.406~2.03μg(r=0.999 8),0.8~4.0μg(r=0.999 8);平均回收率分别为99.74%(RSD 2.53%,n=6),96.14%(RSD 1.31%,n=6),100.10%(RSD 2.73%,n=6)。结论:建立的含量测定方法简便可行、重复性良好,测定12批次河南焦作产怀药鲜地黄提取物中此3种成分的含量,总含量最高20.28%,最低11.32%。故建议鲜地黄提取物中3种原型入血成分梓醇、地黄苷D和益母草苷总含量不得少于15%。
Objective: To develop a method for the determination for three prototype constituents into the blood from the extract of Rehmannia glutinosa.Method: The prototype constituents into the blood from R.glutinosa were confirmed by using the method of serum pharmacochemistry,and then the extracts were determined by HPLC.Inertsil ODS-SP C18 column(4.6 mm × 250 mm,5 μm) was used with acetonitrile-water as mobile phase;the column temperature was kept at 35 ℃,and flow rate was 1 mL.min-1.The detection wavelength was set at 203 nm.Result: It was found that in rat serum catalpol,rehmannioside D and leonuride could enter into the blood in prototype forms.The calibration curves of catalpol,rehmannioside D and leonuride were within 0.32-1.60 μg(r = 0.999 6),0.406-2.03 μg(r = 0.999 8),0.8-4.0 μg(r = 0.999 8).The average recoveries were 99.74%(RSD 2.53%),96.14%(RSD 1.31%) and 100.10%(RSD 2.73%) respectively.Conclusion: The developed methods are simple,feasible and repeatable.They are used to determine three components from 12 batch extracts of R.glutinosa in Jiaozuo district,Henan Province.The maximum total content is 20.28%,and the minimum one is 11.32%.Suggestion that the total content of these three components from the extract of the R.glutinosa must not be less than 15% is provided.
出处
《中国实验方剂学杂志》
CAS
北大核心
2013年第12期66-70,共5页
Chinese Journal of Experimental Traditional Medical Formulae
基金
国家自然科学基金项目(30873442)
国家科技重大专项课题(2011BAI06B02)
关键词
鲜地黄提取物
入血成分
梓醇
地黄苷D
益母草苷
高效液相色谱
extract of fresh Rehmannia glutinosa
content into the blood
catalpol
rehmannioside D
leonuride
HPLC