摘要
以经旋切的卷状聚氨酯泡绵为载体,先在低温下采用等离子表面清洗机清洗载体,再采用磁控溅射技术对泡棉进行导电化处理,对其预镀铁后采用氯化铁体系沉积液电沉积加厚铁镀层,最后采用烧结法除去聚氨酯泡绵骨架,即获得泡沫铁。给出了各个工序的工艺条件,讨论了导电化处理、预镀、加厚电沉积铁、热处理等工艺参数对泡沫铁性能的影响。
Foamed iron was prepared using polyurethane foam as substrate through the following steps： （1） cleaning the substrate with plasma cleaner at low temperature; （2） making the foam conductive by magnetron sputtering; （3） pre-plating iron; （4） thickening the iron coating by plating in a ferrous chloride plating bath; and （5） removing the polyurethane foam by sintering. The operation conditions of individual procedure were presented. The effects of process parameters of electrical conducting treatment, pre-plating, iron plating, and heat treatment on the properties of foamed iron were discussed.
出处
《电镀与涂饰》
CAS
CSCD
北大核心
2012年第2期17-19,共3页
Electroplating & Finishing
关键词
泡沫铁
等离子清洗
磁控溅射
氯化物镀铁
热处理
foamed iron
plasma cleaning
magnetron sputtering
ferrous chloride iron plating
heat treatment
