期刊文献+

液相压力对泡沫分离过程中气泡大小及分离特性的影响 被引量:2

Effects of Pressure on Bubble Size and Separation of Bovine Serum Albumin in a Bubble Column
在线阅读 下载PDF
导出
摘要 研究了液相压力对泡沫分离过程中气泡直径及分布和泡沫分离效果的影响.以牛血清蛋白(BSA)的分离过程为例,采用摄像法测量气泡直径,考察了液相压力和液相高度对分离过程气泡大小及分布和分离效果的影响.结果表明当泡沫分离塔内液相压力的增加时,不同轴向高度处气泡直径逐渐减小并且气泡粒径分布逐渐变窄;液相压力和液相高度的增加也强化了牛血清蛋白的吸附过程,随着液相压力和液相高度的增加,最终分离的富集比回收率均有提高,在最优条件下,牛血清蛋白的富集比和回收率分别为6.73和76.5%. The effects of pressure of bulk liquid phase and liquid height on bubble size distributions and separation of bovine serum albumin in a bubble column were studied taking the separation process of bovine serum albumin(BSA) as an example.The bubble sizes were measured by photographing method.The results showed that with the increased pressure in the column,the average diameter of bubble in the column decreased and the distribution of bubble diameter became narrower;the recovery rate and the enrichment rate increased with the increased liquid pressure and the liquid height,Therefore the increased liquid pressure and liquid height have strengthened the process of BSA adsorption.Under the optimum conditions,the recovery rate was 76.5% and the enrichment was 6.73.
出处 《河北工业大学学报》 CAS 北大核心 2010年第6期62-65,71,共5页 Journal of Hebei University of Technology
基金 天津市应用基础及前沿技术研究计划重点资助项目(08JCZDJC25200)
关键词 泡沫分离 压力 气泡 富集比 回收率 foam separation pressure bubble enrichment ratio recovery rate
  • 相关文献

参考文献15

  • 1宋伟光,吴兆亮,刘桂敏,李佥,吴海艳.泡沫分离除去水溶液中微量金属离子[J].高校化学工程学报,2008,22(5):900-905. 被引量:15
  • 2Wong C H, Monwar Honwar M, Davies C E. Performance of a continuous foam separation column as a function of process variables [J]. Bioprocess Biosyst Eng, 2001, 24: 73-81.
  • 3Behkish A, Men Z, Inga J R, et al. Mass transfer characteristics in a large-scale slurry bubble colunm reactor operating with an organic liquid mixtures [J]. Chem Eng Sci, 2002, 57: 3307-3324.
  • 4Majuumder S K, Kundu G, Mukherjee D. Bubble size distribution and gas-liquid interracial area in a modified downflow bubble column [J]. Chem Eng J, 2006, 122: 1-10.
  • 5Du L, Prokop A, Tanner R D. Variation of bubble size distribution in a protein foam fractionation column measured using a capillary probe with photoelectric sensors [J]. J Colloid Interface Sci, 2003, 259: 180-185.
  • 6Dhotre M T, Joshi J B, et al. CFD simulation ofsparger design and height to diameter ration on gas holdup profiles in bubble column reactors [J]. Chem Eng J, 2004, 28.. 407-421.
  • 7Letzel H M, Schouten J C, VandenBleek C M, et al. Influence of elevated pressure on the stability of bubbly flows [J]. Chem Eng Sci, 1997, 52: 3733-3739.
  • 8Wongsuchoto P, Charinpanitkul T, Pavasant P. Bubble size distribution and gas-liquid mass transfer in airlift contactors [J]. Chem Eng J, 2003, 92: 81-90.
  • 9Xie W, Neethling S J, Cilliers J J. A novel approach for estimating the average bubble size for foams flowing in vertical columns [J]. Chem Eng Sci, 2004, 59.. 81-86.
  • 10Pohorecki R, Moniuk W, Bielski P, et al. Diameter of bubble column reactors operating with organic liquids [J]. Chem Eng J, 2005, 83: 827-832.

二级参考文献15

共引文献28

同被引文献37

引证文献2

二级引证文献6

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部