期刊文献+

银基离子聚合物金属复合材料的制备和驱动特性 被引量:4

Manufacture and Actuating Characteristic of Ionic Polymer Metal Composites with Silver Electrodes
原文传递
导出
摘要 用化学沉积法制备银基IPMC(Ag-IPMC),用扫描电镜和能谱分析仪研究其表面形貌和表面电极化学成分。结果表明,Ag在离子交换膜内部和外表面的沉积效果良好;对Ag-IPMC试件的直流驱动、不同状态下的含水特性以及拉力输出的测试结果表明,低电压(小于1.6 V)刺激可使Ag-IPMC试件产生大变形,其输出拉力可达自重的89倍。各项性能与激励电压的关系表明,Ag-IPMC的最佳直流激励电压为0.6-1.2 V。 Ag-IPMC was fabricated by using chemical deposition methods in this paper.The topography and chemical composition of the surface electrodes of Ag-IPMC were analyzed by scanning electron microscopy(SEM) and energy dispersive spectrum(EDS).And the DC-Actuating ability,moisture characteristic of different states and the performance of tensile output were tested.The results show that Ag deposits well both inside and outside of the exchange membrane.Ag-IPMC exhibits large deflection and significant tensile force for the stimulation of low voltage(less than 1.6 V).The relationship between various performance and excitation voltage shows that the best DC-excitation voltage for Ag-IPMC is 0.6-1.2 V.
出处 《材料研究学报》 EI CAS CSCD 北大核心 2010年第5期520-524,共5页 Chinese Journal of Materials Research
基金 国家自然科学基金90605003资助项目~~
关键词 复合材料 离子聚合物金属复合材料 化学沉积 Ag电极 含水率 拉力输出 composites IPMC chemical deposition Ag electrodes moisture content tensile output
  • 相关文献

参考文献2

二级参考文献22

  • 1戴振东,于敏,吉爱红,郭策,张昊.动物驱动足摩擦学特性研究及仿生设计[J].中国机械工程,2005,16(16):1454-1457. 被引量:20
  • 2刘斌,孙向英,徐金瑞,金继业,三轮智夫.Pb(Ⅱ)在Nafion修饰电极上的机理研究 (Ⅱ)富集过程中的离子交换和物理扩散[J].华侨大学学报(自然科学版),1996,17(1):14-17. 被引量:1
  • 3Shahinpoor M,Kwang J Kim. Novel Ionic Polymer-metal Composites Equipped with Physically Loaded Particulate Electrodes as Biomimetic Sensors, Actuators and Artificial Muscles[J]. Sensor and Actuators, 2002, 96:125~ 132.
  • 4Sia Nemat Nasser,Jiang Y L. Electromechanical Response of Ionic Poly-metal Composites[J]. Journal of Applied Physics,1999,87(7): 3321~3331.
  • 5扬大智.智能材料与智能系统[M].天津:天津大学出版社,2000.337.
  • 6Shahinpoor M,Kwang J Kim. The Effect of Surface electrode Resistance on the Performance of Ionic Polymer-metal Composite Artificial Muscles[J]. Smart Material and Structures Journal, 2000,9 (4): 543 ~ 551.
  • 7Kwang J Kim, Shahinpoor M. A Novel Method of Manufacturing Three-dimensional Ionic Polymer-metal Composites Biomimetic Sensors, Actuators and Artificial Muscles[J]. Polymer, 2002, 43: 797~802.
  • 8Sia Nemat Nasser. Micromechanics of Actuation of IPMC[J]. Journal of Applied Physics, 2002,92(5):1~21.
  • 9Kucernak A R, Muir B. Analysis of the Electrical and Mechanical Time Response of Solid Polymer-platinum Composite Membranes[J]. Electrochemica Acta, 2001, 46: 1313~1322.
  • 10Shahinpoor M,Kwang J Kim. Ionic Polymer metal Composites[J]. Smart Mater Struct, 2001,10:813~819.

共引文献27

同被引文献56

  • 1Shahinpoor M, Kim Kwang J. Novel ionic polymer - metalcomposites equipped with physically loaded particulateelectrodes as biomimetic sensors. actuators and artificial muscles[J]. Sensors and Actuators A, 2002,96(2/3) : 125-132.
  • 2Jung K, Nam J, Choi H. Investigations on actuationcharacteristics of IPMC artificial muscle actuator [J]. Sensorsand Actuators A,2003,107(2) : 183-192.
  • 3Shahinpoor M, Kim Kwang J. The effect of surface-electroderesistance on the performance of ionic polymer - metalcomposite (IPMC) artificial muscles [J]. Smart Materials andStructures, 2000,9 : 543-551.
  • 4Nemat- Nasser S, Li J Y. Electromechanical response of ionicpolymer - metal composites [J], Journal of Applied Physics,2000, 7(87): 61-68.
  • 5Shahinpoor M, Kim Kwang J. Ionic polymer - metalcomposites: I — Fundamentals [J]. Smart Materials andStructures, 2001,10: 819-833.
  • 6Kim Kwang J, Shahinpoor M. Ionic polymer - metalcomposites: II — Manufacturing techniques [ J ]. SmartMaterials and Structures, 2003,12: 65-79.
  • 7Bonomo C,Fortuna L, Giannone P, et al. A method tocharacterize the deformation of an IPMC sensing membrane[J]. Sensors and Actuators A, 2005,123/124: 146-154.
  • 8Kim B, Kim D H,Jung J, et al. A biomimetic undulatorytadpole robot using ionic polymer - metal composite actuators[J]. Smart Materials and Structures, 2005,14: 1579-1585.
  • 9Biddiss E,Chau T. Electroactive polymeric sensors in handprostheses : Bending response of an ionic polymer metalcomposite [J]. Medical Engineering & Physics, 2006,28(6):568-578.
  • 10Kim K J, Shahinpoor M. Ionic polymer - metal composites:IV — Industrial and medical applications [J]. Smart Materialsand Structures, 2005, 14: 197-214.

引证文献4

二级引证文献9

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部