期刊文献+

大气污染物综合排放标准的编制技术方法 被引量:2

Technical method of development the integrated emission standard of air pollutants
在线阅读 下载PDF
导出
摘要 我国《大气污染综合排放标准》规定了33种大气污染物的排放限值和执行要求。标准提出了一个污染源必须同时遵守最高允许排放浓度;最高允许排放速率和无组织排放监控浓度限值三项限制指标。以众多企业的排放数据和“最佳实用治理技术”为依据制定排放浓度限值;以环境质量要求和全国大部分地区的中性气象条件为依据,经计算后确定排放速率限值;以污染源周界环境空气浓度达到质量标准要求确定无组织排放限值。经过一定范围的调查检验后,表明该标准具有基本适宜的宽严程度。 The Integrated Emission Standard of Air Pollutants stipulates the requirements of emission of 33 air pollutants,as well as its implementation.Each stationary pollution source must comply with all of three indexes.Among them,the maximum allowable concentration limits are set up based on the emission data from different sources and Best Practical Technology(BPT),the emission rate limits are formulated according to the requirement of environmental quality and the medium meterollogical condition in most areas of Chian,and the control limits of diffusion source are determined by the requirement of ambient air concentration around pollution source,the concentration is based on the requirement of the environmental quality standard.After a careful investigation and observation in certain area,it proves that standard is practical and feasible.
出处 《中国环境科学》 EI CAS CSSCI CSCD 北大核心 1997年第4期365-368,共4页 China Environmental Science
关键词 排放标准 大气 污染物 编制技术 emission standard,emission concentration,emission rate,diffusion source.
  • 相关文献

参考文献4

  • 1团体著者,国家环境保护最佳实用技术,1994年
  • 2洪燕峰,卫生研究,1993年,12卷
  • 3团体著者,环境质量与污染物排放国家标准汇编,1992年
  • 4团体著者,GB/T3840-91制定地方大气污染物排放标准的技术原则与方法,1991年

同被引文献28

  • 1董志根.预报SO2浓度的一种方法[J].环境科学,1983,4(5).
  • 2积水源.城市大气污染物长期平均浓度计算方法研究[J].环境科学丛刊,1989,11(2):44-47.
  • 3陈文颖.大气污染总量控制规划智能决策支持系统的开发研究[J].中国环境科学,1977,17(1):30-33.
  • 4马福建.大气扩散模式评论[M].南京大学出版社,1989..
  • 5王淑芳.北京城近郊区大气污染评价的气质模式[J].中国环境科学,1989,:46-53.
  • 6王彦昌.城市大气污染(SO2)与气象关系的初步分析[J].环境科学,1981,2(1).
  • 7陈文颖,中国环境科学,1977年,17卷,1期,30页
  • 8积水源,环境科学丛刊,1989年,11卷,2期,44页
  • 9王淑芳,中国环境科学,1989年,46页
  • 10马福建(译),大气扩散模式评论,1989年

引证文献2

二级引证文献18

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部