摘要
采用实验-数值相结合的方法对40Cr和30CrMnSiNi2A两种高强钢剪切试样在冲击载荷作用下的Ⅱ型动态断裂韧性进行了测试．实验在Hopkinson压杆系统上完成,试样的起裂时间采用应变片法测得．结合有限元三维动态模拟,得到了不同加载速率下试样动态应力强度因子的时间历程,并由实测的起裂时间确定两种钢的动态断裂韧性．结果表明,在现有加载率范围 (2×106-7×106MPa．m1／2／s)内,两种高强钢试样几乎全部由绝热剪切模式引发断裂,其动态断裂韧性均随加载速率的增加而呈现上升趋势,且在相同加载速率下后者的动态断裂韧性大于前者的动态断裂韧性．并对韧带尺寸对试样断裂韧性的影响进行了研究．
Mode Ⅱ dynamic fracture toughnesses KIId for high strength steels, 40Cr and 30CrMnSiNi2A, subjected to impact loading were measured using an experiment-number combined method. The tests were performed on shear specimens with Hopkinson pressure bar and the time of crack initiation was determined by strain gauge. With 3-D transient finite element analysis, the time evolution of dynamic stress intensity factor under different loading rates was obtained and the dynamic fracture toughness was determined by fracture initiation time. The results show that within the loading rate range （2×10^6-7×10^6MPa·m^1/2/s）, almost all the specimens failed by adiabatic shear bands and the KIId Values of the two steels increase with increasing loading rate. The KIId value of 30CrMnSiNi2A is larger than that of 40Cr at the same loading rate. The effect of ligament size on fracture toughness was also discussed.
出处
《金属学报》
SCIE
EI
CAS
CSCD
北大核心
2006年第6期635-640,共6页
Acta Metallurgica Sinica
基金
国家自然科学基金委员会和中国工程物理研究院联合基金资助项目10276033
关键词
高强钢
加载速率
剪切载荷
动态断裂韧性
动态应力强度因子
high strength steel, loading rate, shear loading, dynamic fracture toughness, dynamic stress intensity factor （DSIF）
