摘要
在Pro/E环境下对初步设计的夹钳机构进行建模、装配及运动学仿真分析,发现模型运动学特性较差。为改善机构的运动学特性,将模型通过M echan ism/Pro接口程序导入ADAMS中进行优化设计,得到了改进机构运动特性的方法。在Pro/E下改进机构模型并再次进行运动学仿真,验证了改进结果的合理性。最后,通过平面几何知识对改进方法的合理性进行了证明。仿真结果表明,利用Pro/E和ADAMS联合仿真的方法可以为机械系统结构的优化设计提供一条有效途径。
Through the modeling, assembling and kinematic simulation analysis of the initially established clamp model under the environment of Pro/E, bad kinematic traits were found. The model was introduced to ADAMS through the Mechanism/Pro interface to optimize the kinematic traits and the method to improve the model was achieved. This method was validated in reason by improving the model and simulating once again under Pro/E. At last, the mothod was proved to be right through plane geometry knowledge, and the results show that the co-simulating analysis of Pro/E and ADAMS can offer a valid method for the design and optimization of mechanical structures.
出处
《机械设计与研究》
CSCD
北大核心
2006年第1期48-51,共4页
Machine Design And Research
