摘要
以钼酚醛树脂为原料基体,添加适量的钼粉,对炭炭复合材料进行连接试验,测试了不同温度处理后接头的室温剪切强度。结果表明,经1500℃处理后接头仍保持较高的连接强度,可达13.3MPa。利用XRD和SEM研究了接头的组成和形貌,发现添加适量钼粉后,不但可以降低酚醛树脂在炭化过程中的体积收缩,还能在1100℃时原位生成Mo2C来提高接头的连接强度。
Carbon-carbon composites had been joined by using molybdenum phenolic resin mixed with molybdenum powders. The shear strength of the joint heat-treated at different temperatures were tested at room temperature. The results show that a satisfactory shear strength of 13.3MPa obtains for the joint after heat-treatment at 1500℃. SEM and XRD were used to analyze microstructure and component of the joint. Molybdenum powders can not only reduce the volume shrinking when molybdenum phenolic resin is carbonized, but form in situ single-phase Mo_2C by chemical reactions between C and Mo at 1100℃.Therefore, the strength of joint is enhanced.
出处
《材料热处理学报》
EI
CAS
CSCD
北大核心
2005年第4期5-7,共3页
Transactions of Materials and Heat Treatment
基金
国家自然科学基金项目(50172039)
国家杰出青年基金(50225210)
