摘要
解决碳分氢氧化铝强度较低、细粒子含量较高的问题是烧结法生产砂状氧化铝的关键. 本研究通过外加晶种研究了铝酸钠溶液碳酸化分解产物氢氧化铝的粒度、强度和结晶形貌,并通过正交实验确定了添加晶种时改善产物粒度和强度的合理工艺条件. 实验对比了添加晶种与相应条件下未添加晶种的情况,结果表明产物氢氧化铝的粒度受晶种粒度影响,且其作用程度受晶种类别和晶种系数的制约;晶种促进了单晶间的交互生长,产物氢氧化铝为近似球形的'镶嵌'式多晶体;选用晶种可降低产物磨损指数3%～25%.
Poor product strength and excessive fine particle content are the main problems to be solved in sandy alumina production. Carbonization was investigated through adding seeds to sodium aluminate liquor, and orthogonal experiments were conducted on operation conditions in order to improve the particle size and strength of products. By comparison of mean particle size, attrition index and micrographs of products under the conditions with and without seed, it was shown that seeds played important roles in the carbonization process, and the product mean particle size was influenced by that of seed, but its effect was related to seed type and seed ratio. In addition, seeds could accelerate the inter-growth of unit crystal, as a result the strength of products was increased by 3%~25%.
出处
《过程工程学报》
EI
CAS
CSCD
北大核心
2005年第1期78-81,共4页
The Chinese Journal of Process Engineering
基金
国家十五科技攻关资助项目(编号:2001-BA609A-18)
关键词
铝酸钠溶液
碳酸化分解
晶种
粒度
强度
sodium aluminate solution
carbonization
seed
particle size
strength
