Wave shapes that induce velocity skewness and acceleration asymmetry are usually responsible for onshore sediment transport, whereas undertow and bottom slope effect normally contribute to offshore sediment transport....Wave shapes that induce velocity skewness and acceleration asymmetry are usually responsible for onshore sediment transport, whereas undertow and bottom slope effect normally contribute to offshore sediment transport. By incorporating these counteracting driving forces in a phase-averaged manner, the theoretically-based quasi-steady formula of Wang （2007） is modified to predict the magnitude and direction of net cross-shore total load transport under the coaction of wave and current. The predictions show an excellent agreement with the measurement data on medium and fine sand collected by Dohmen-Janssen and Hanes （2002） and Schretlen （2012） in a full-scale wave flume at the Coastal Research Centre in Hannover, Germany. The modified formula can predict the net onshore transport of fine sand in sheet flows. In particular, it can predict the net offshore transport of medium sand in rippled beds through enlarged bed roughness, as well as the net offshore transport of fine-to-coarse sand in sheet flows with the aid of a new criterion to judge the occurrence of net offshore transport.展开更多
To remove the scalar ambiguity in conventional blind channel estimation algorithms, totally blind channel estimation （TBCE） is proposed by using multiple constellations. To estimate the unknown scalar, its phase is ...To remove the scalar ambiguity in conventional blind channel estimation algorithms, totally blind channel estimation （TBCE） is proposed by using multiple constellations. To estimate the unknown scalar, its phase is decomposed into a fractional phase and an integer phase. However, the maximum-likelihood （ML） algorithm for the fractional phase does not have closed-form solutions and suffers from high computational complexity. By ex- ploring the structures of widely used constellations, this paper proposes a low-complexity fractional phase estimation algorithm which requires no exhaustive search. Analytical expressions of the asymptotic mean squared error （MSE） are also derived. The theo- retical analysis and simulation results indicate that the proposed fractional phase estimation algorithm exhibits almost the same performance as the ML algorithm but with significantly reduced computational burden.展开更多
This paper investigates the effect of the Phase Angle Error of a Constant Amplitude Voltage signal in determining the Total Vector Error (TVE) of the Phasor Measurement Unit (PMU) using MATLAB/Simulink. The phase angl...This paper investigates the effect of the Phase Angle Error of a Constant Amplitude Voltage signal in determining the Total Vector Error (TVE) of the Phasor Measurement Unit (PMU) using MATLAB/Simulink. The phase angle error is measured as a function of time in microseconds at four points on the IEEE 14-bus system. When the 1 pps Global Positioning System (GPS) signal to the PMU is lost, sampling of voltage signals on the power grid is done at different rates as it is a function of time. The relationship between the PMU measured signal phase angle and the sampling rate is established by injecting a constant amplitude signal at two different points on the grid. In the simulation, 64 cycles per second is used as the reference while 24 cycles per second is used to represent the fault condition. Results show that a change in the sampling rate from 64 bps to 24 bps in the PMUs resulted in phase angle error in the voltage signals measured by the PMU at four VI Measurement points. The phase angle error measurement that was determined as a time function was used to determine the TVE. Results show that (TVE) was more than 1% in all the cases.展开更多
AIM: Variation in structure-related components in plant products prompted the trend to establish methods, using multiple or total analog analysis, for their effective quality control. However, the general use of routi...AIM: Variation in structure-related components in plant products prompted the trend to establish methods, using multiple or total analog analysis, for their effective quality control. However, the general use of routine quality control is restricted by the limited availability of reference substances. Using an easily available single marker as a reference standard to determine multiple or total analogs should be a practical option. METHOD: In this study, the Ultra-HPLC method was used for the baseline separation of the main components in ginseng extracts. Using a plant chemical component database, ginsenosides in ginseng extracts were identified by Ultra-HPLC-MS analysis. The charged aerosol detection(CAD) system with post-column compensation of the gradient generates a similar response for identical amounts of different analytes, and thus, the content of each ginsenoside in ginseng extracts was determined by comparing the analyte peak area with the reference standard(determination of total analogs by single marker, DTSM). The total ginsenoside content was determined by the summation of reference standard and other ginsenoside components. RESULTS: The results showed that DTSM approaches were available for the determination of total ginsenosides in a high purity ginseng extract because of the removal of impurities. In contrast, DTSM approaches might be suitable for determination of multiple ginsenosides without interference from impurities in the crude ginseng extract. CONCLUSION: Future practical studies similar to the present study should be conducted to verify that DTSM approaches based on CAD with post-column inverse gradient for uniform response are ideal for the quality control of plant products.展开更多
A novel method for the preparation of single-phase ammonium dimolybdate with industrial ammonium molybdate was studied. Various in- fluential factors were evaluated in the paper, including reaction temperature, reacti...A novel method for the preparation of single-phase ammonium dimolybdate with industrial ammonium molybdate was studied. Various in- fluential factors were evaluated in the paper, including reaction temperature, reaction time, initial molybdenum concentration, initial NH_3 /Mo molar ratio, and stirring speed. Under the optimum experimental conditions, the crystallization rate of product is 85.23%. The X-ray diffraction (XRD) analysis and chemical analysis show that the product is single-phase ammonium dimolybdate, and no impurity phases exist. The scanning electronic microscope (SEM) image reveals uniform particle size, good particle dispersion, and no agglomeration between particles. Meanwhile, the final pH value of acidification was investigated. The total molybdenum recovery can reach up to 99.40%, and the main phases of acidification product are the same as those of raw material with the final pH value of 1.5. This determines that the acidification product can be used as a raw material to produce single-phase ammonium dimolybdate.展开更多
In this work, attempts were made to estimate the total oil content (TOC) in single peanut kernels, using the CI meter (Chari’s Impedance meter, described below). Mature peanut kernels of selected varieties with a ran...In this work, attempts were made to estimate the total oil content (TOC) in single peanut kernels, using the CI meter (Chari’s Impedance meter, described below). Mature peanut kernels of selected varieties with a range of oil contents from 47% to 61% were placed one at a time, between the parallel-plate electrodes of the CI meter, and the impedance (Z) and phase angle (q) of the system were measured, and capacitance, C was computed at 1, 5 and 9 MHz. After the measurements, the TOC of each kernel was determined by Soxhlet method. Using the known TOC values, and the corresponding C, Z and q values, initially on a calibration group of kernels, calibration equations were developed. Using the model coefficients from the calibration, the TOCs of kernel samples of 31 diverse peanut genotypes grown in different environments in Australia were determined. The method predicted the TOC values of peanut kernels of 31 peanut genotypes, within 2% of the Soxhlet values, with an R2 of 0.87 (P 0.001).展开更多
To represent well the characteristics of temporal and spatial distributions, chart of 3-dekad moving total precipitation is proposed in this paper first. Then this kind of chart is expanded in terms of Chebyshev polyn...To represent well the characteristics of temporal and spatial distributions, chart of 3-dekad moving total precipitation is proposed in this paper first. Then this kind of chart is expanded in terms of Chebyshev polynomial at irregular grids, and the quantitative representation of precipitation is got. Finally the Chebyshev coefficients are forecasted by using the forecasting method of vector similarity in phase space proposed by Zhou (1992). Using above mentioned procedures temporal and spatial distributions of precipitation over the Huanghe-- Huaihe-- H aihe Plain in China are forecasted.展开更多
基金supported by the National Natural Science Foundation of China(Grant No.51179211)
文摘Wave shapes that induce velocity skewness and acceleration asymmetry are usually responsible for onshore sediment transport, whereas undertow and bottom slope effect normally contribute to offshore sediment transport. By incorporating these counteracting driving forces in a phase-averaged manner, the theoretically-based quasi-steady formula of Wang （2007） is modified to predict the magnitude and direction of net cross-shore total load transport under the coaction of wave and current. The predictions show an excellent agreement with the measurement data on medium and fine sand collected by Dohmen-Janssen and Hanes （2002） and Schretlen （2012） in a full-scale wave flume at the Coastal Research Centre in Hannover, Germany. The modified formula can predict the net onshore transport of fine sand in sheet flows. In particular, it can predict the net offshore transport of medium sand in rippled beds through enlarged bed roughness, as well as the net offshore transport of fine-to-coarse sand in sheet flows with the aid of a new criterion to judge the occurrence of net offshore transport.
基金supported by the National Science and Technology Major Project of China(2013ZX03003006-003)
文摘To remove the scalar ambiguity in conventional blind channel estimation algorithms, totally blind channel estimation （TBCE） is proposed by using multiple constellations. To estimate the unknown scalar, its phase is decomposed into a fractional phase and an integer phase. However, the maximum-likelihood （ML） algorithm for the fractional phase does not have closed-form solutions and suffers from high computational complexity. By ex- ploring the structures of widely used constellations, this paper proposes a low-complexity fractional phase estimation algorithm which requires no exhaustive search. Analytical expressions of the asymptotic mean squared error （MSE） are also derived. The theo- retical analysis and simulation results indicate that the proposed fractional phase estimation algorithm exhibits almost the same performance as the ML algorithm but with significantly reduced computational burden.
文摘This paper investigates the effect of the Phase Angle Error of a Constant Amplitude Voltage signal in determining the Total Vector Error (TVE) of the Phasor Measurement Unit (PMU) using MATLAB/Simulink. The phase angle error is measured as a function of time in microseconds at four points on the IEEE 14-bus system. When the 1 pps Global Positioning System (GPS) signal to the PMU is lost, sampling of voltage signals on the power grid is done at different rates as it is a function of time. The relationship between the PMU measured signal phase angle and the sampling rate is established by injecting a constant amplitude signal at two different points on the grid. In the simulation, 64 cycles per second is used as the reference while 24 cycles per second is used to represent the fault condition. Results show that a change in the sampling rate from 64 bps to 24 bps in the PMUs resulted in phase angle error in the voltage signals measured by the PMU at four VI Measurement points. The phase angle error measurement that was determined as a time function was used to determine the TVE. Results show that (TVE) was more than 1% in all the cases.
基金supported by the National Natural Science Foundation of China(81303246)the Jiangsu Provincial Natural Science Foundation of China(BK2011815)+1 种基金the ‘Qing Lan’ Project from Jiangsu Provincial Framework Teacher Support Schemethe Projects of priority-discipline for colleges and universities of Jiangsu Province
文摘AIM: Variation in structure-related components in plant products prompted the trend to establish methods, using multiple or total analog analysis, for their effective quality control. However, the general use of routine quality control is restricted by the limited availability of reference substances. Using an easily available single marker as a reference standard to determine multiple or total analogs should be a practical option. METHOD: In this study, the Ultra-HPLC method was used for the baseline separation of the main components in ginseng extracts. Using a plant chemical component database, ginsenosides in ginseng extracts were identified by Ultra-HPLC-MS analysis. The charged aerosol detection(CAD) system with post-column compensation of the gradient generates a similar response for identical amounts of different analytes, and thus, the content of each ginsenoside in ginseng extracts was determined by comparing the analyte peak area with the reference standard(determination of total analogs by single marker, DTSM). The total ginsenoside content was determined by the summation of reference standard and other ginsenoside components. RESULTS: The results showed that DTSM approaches were available for the determination of total ginsenosides in a high purity ginseng extract because of the removal of impurities. In contrast, DTSM approaches might be suitable for determination of multiple ginsenosides without interference from impurities in the crude ginseng extract. CONCLUSION: Future practical studies similar to the present study should be conducted to verify that DTSM approaches based on CAD with post-column inverse gradient for uniform response are ideal for the quality control of plant products.
基金supported by the National Natural Science Foundation of China(No.51072233)
文摘A novel method for the preparation of single-phase ammonium dimolybdate with industrial ammonium molybdate was studied. Various in- fluential factors were evaluated in the paper, including reaction temperature, reaction time, initial molybdenum concentration, initial NH_3 /Mo molar ratio, and stirring speed. Under the optimum experimental conditions, the crystallization rate of product is 85.23%. The X-ray diffraction (XRD) analysis and chemical analysis show that the product is single-phase ammonium dimolybdate, and no impurity phases exist. The scanning electronic microscope (SEM) image reveals uniform particle size, good particle dispersion, and no agglomeration between particles. Meanwhile, the final pH value of acidification was investigated. The total molybdenum recovery can reach up to 99.40%, and the main phases of acidification product are the same as those of raw material with the final pH value of 1.5. This determines that the acidification product can be used as a raw material to produce single-phase ammonium dimolybdate.
文摘In this work, attempts were made to estimate the total oil content (TOC) in single peanut kernels, using the CI meter (Chari’s Impedance meter, described below). Mature peanut kernels of selected varieties with a range of oil contents from 47% to 61% were placed one at a time, between the parallel-plate electrodes of the CI meter, and the impedance (Z) and phase angle (q) of the system were measured, and capacitance, C was computed at 1, 5 and 9 MHz. After the measurements, the TOC of each kernel was determined by Soxhlet method. Using the known TOC values, and the corresponding C, Z and q values, initially on a calibration group of kernels, calibration equations were developed. Using the model coefficients from the calibration, the TOCs of kernel samples of 31 diverse peanut genotypes grown in different environments in Australia were determined. The method predicted the TOC values of peanut kernels of 31 peanut genotypes, within 2% of the Soxhlet values, with an R2 of 0.87 (P 0.001).
文摘To represent well the characteristics of temporal and spatial distributions, chart of 3-dekad moving total precipitation is proposed in this paper first. Then this kind of chart is expanded in terms of Chebyshev polynomial at irregular grids, and the quantitative representation of precipitation is got. Finally the Chebyshev coefficients are forecasted by using the forecasting method of vector similarity in phase space proposed by Zhou (1992). Using above mentioned procedures temporal and spatial distributions of precipitation over the Huanghe-- Huaihe-- H aihe Plain in China are forecasted.
