Previous studies showed that an axisymmetric hub-initiated disturbance defined as partial surge may initiate the stall of a transonic compressor; to reveal the instability evolution under full-span incompressible flow...Previous studies showed that an axisymmetric hub-initiated disturbance defined as partial surge may initiate the stall of a transonic compressor; to reveal the instability evolution under full-span incompressible flow for different levels of hub loading and B parameter, an experimental investigation is conducted on a single-stage low-speed compressor. Experimental results show that under a uniform inflow condition without inlet flow distortion, a modal-type stall inception dominates in this low-speed compressor. When an inlet screen introducing hub distortion is used to increase the hub loading, a compressor stall is initiated by a modal wave, but large disturbances are present in the hub region before the compressor stall, which become stronger as the hub loading increases. Under high hub loading and large B parameter（implemented by adding hub distortion through an inlet screen and enlarging the outlet plenum volume, respectively）, a compressor stall is triggered by an axisymmetric hub-initiated disturbance, which is much different from the modal-like disturbances. The beginning of this axisymmetric disturbance may be captured over 800 rotor revolutions prior to the onset of stall, and the amplitude grows with time. The disturbance is hub-initiated because the disturbance signal at the hub is detected much earlier than that at the tip; meanwhile, the frequency of this axisymmetric disturbance changes with the length of the inlet duct. The characteristics of instability evolution in the low-speed compressor are also compared with those in a transonic compressor.展开更多
The circumferentially averaged equation of the inlet flow radial equilibrium in axial compressor was deduced. It indicates that the blade inlet radial pressure gradient is closely related to the radial component of th...The circumferentially averaged equation of the inlet flow radial equilibrium in axial compressor was deduced. It indicates that the blade inlet radial pressure gradient is closely related to the radial component of the circumferential fluctuation（CF） source item. Several simplified cascades with/without aerodynamic loading were numerically studied to investigate the effects of blade bowing on the inlet flow radial equilibrium. A data reduction program was conducted to obtain the CF source from three-dimensional（3D） simulation results. Flow parameters at the passage inlet were focused on and each term in the radial equilibrium equation was discussed quantitatively. Results indicate that the inviscid blade force is the inducement of the inlet CF due to geometrical asymmetry. Blade bowing induces variation of the inlet CF, thus changes the radial pressure gradient and leads to flow migration before leading edge（LE） in the cascades. Positive bowing drives the inlet flow to migrate from end walls to mid-span and negative bowing turns it to the reverse direction to build a new equilibrium. In addition, comparative studies indicate that the inlet Mach number and blade loading can efficiently impact the effectiveness of blade bowing on radial equilibrium in compressor design.展开更多
This paper presents comparative numerical studies to investigate the effects of blade sweep on inlet flow in axial compressor cascades. A series of swept and straight cascades was modeled in order to obtain a general ...This paper presents comparative numerical studies to investigate the effects of blade sweep on inlet flow in axial compressor cascades. A series of swept and straight cascades was modeled in order to obtain a general understanding of the inlet flow field that is induced by sweep.A computational fluid dynamics（CFD） package was used to simulate the cascades and obtain the required three-dimensional（3D） flow parameters. A circumferentially averaged method was introduced which provided the circumferential fluctuation（CF） terms in the momentum equation.A program for data reduction was conducted to obtain a circumferentially averaged flow field.The influences of the inlet flow fields of the cascades were studied and spanwise distributions of each term in the momentum equation were analyzed. The results indicate that blade sweep does affect inlet radial equilibrium. The characteristic of radial fluid transfer is changed and thus influencing the axial velocity distributions. The inlet flow field varies mainly due to the combined effect of the radial pressure gradient and the CF component. The axial velocity varies consistently with the incidence variation induced by the sweep, as observed in the previous literature. In addition, factors that might influence the radial equilibrium such as blade camber angles, solidity and the effect of the distance from the leading edge are also taken into consideration and comparatively analyzed.展开更多
基金the supports of the National Natural Science Foundation of China (Nos.51636001 and 51706008)Aeronautics Power Foundation of China (No.6141B090315)China Postdoctoral Science Foundation (No.2017M610742)
文摘Previous studies showed that an axisymmetric hub-initiated disturbance defined as partial surge may initiate the stall of a transonic compressor; to reveal the instability evolution under full-span incompressible flow for different levels of hub loading and B parameter, an experimental investigation is conducted on a single-stage low-speed compressor. Experimental results show that under a uniform inflow condition without inlet flow distortion, a modal-type stall inception dominates in this low-speed compressor. When an inlet screen introducing hub distortion is used to increase the hub loading, a compressor stall is initiated by a modal wave, but large disturbances are present in the hub region before the compressor stall, which become stronger as the hub loading increases. Under high hub loading and large B parameter（implemented by adding hub distortion through an inlet screen and enlarging the outlet plenum volume, respectively）, a compressor stall is triggered by an axisymmetric hub-initiated disturbance, which is much different from the modal-like disturbances. The beginning of this axisymmetric disturbance may be captured over 800 rotor revolutions prior to the onset of stall, and the amplitude grows with time. The disturbance is hub-initiated because the disturbance signal at the hub is detected much earlier than that at the tip; meanwhile, the frequency of this axisymmetric disturbance changes with the length of the inlet duct. The characteristics of instability evolution in the low-speed compressor are also compared with those in a transonic compressor.
基金supported by the National Natural Science Foundation of China (Nos.51236001,51006005)the National Basic Research Program of China (No. 2012CB720201)Beijing Natural Science Foundation (No. 3151002)
文摘The circumferentially averaged equation of the inlet flow radial equilibrium in axial compressor was deduced. It indicates that the blade inlet radial pressure gradient is closely related to the radial component of the circumferential fluctuation（CF） source item. Several simplified cascades with/without aerodynamic loading were numerically studied to investigate the effects of blade bowing on the inlet flow radial equilibrium. A data reduction program was conducted to obtain the CF source from three-dimensional（3D） simulation results. Flow parameters at the passage inlet were focused on and each term in the radial equilibrium equation was discussed quantitatively. Results indicate that the inviscid blade force is the inducement of the inlet CF due to geometrical asymmetry. Blade bowing induces variation of the inlet CF, thus changes the radial pressure gradient and leads to flow migration before leading edge（LE） in the cascades. Positive bowing drives the inlet flow to migrate from end walls to mid-span and negative bowing turns it to the reverse direction to build a new equilibrium. In addition, comparative studies indicate that the inlet Mach number and blade loading can efficiently impact the effectiveness of blade bowing on radial equilibrium in compressor design.
基金support of the National Natural Science Foundation of China(Grant Nos:51236001,51006005)
文摘This paper presents comparative numerical studies to investigate the effects of blade sweep on inlet flow in axial compressor cascades. A series of swept and straight cascades was modeled in order to obtain a general understanding of the inlet flow field that is induced by sweep.A computational fluid dynamics（CFD） package was used to simulate the cascades and obtain the required three-dimensional（3D） flow parameters. A circumferentially averaged method was introduced which provided the circumferential fluctuation（CF） terms in the momentum equation.A program for data reduction was conducted to obtain a circumferentially averaged flow field.The influences of the inlet flow fields of the cascades were studied and spanwise distributions of each term in the momentum equation were analyzed. The results indicate that blade sweep does affect inlet radial equilibrium. The characteristic of radial fluid transfer is changed and thus influencing the axial velocity distributions. The inlet flow field varies mainly due to the combined effect of the radial pressure gradient and the CF component. The axial velocity varies consistently with the incidence variation induced by the sweep, as observed in the previous literature. In addition, factors that might influence the radial equilibrium such as blade camber angles, solidity and the effect of the distance from the leading edge are also taken into consideration and comparatively analyzed.
