In this paper, composite film based on polyvinylpyrrolidone(PVP)/graphene oxide(GO) was fabricated by spray method on AT-cut 9.986 MHz quartz crystal microbalance(QCM) for NH_3 sensing. The thin films were characteriz...In this paper, composite film based on polyvinylpyrrolidone(PVP)/graphene oxide(GO) was fabricated by spray method on AT-cut 9.986 MHz quartz crystal microbalance(QCM) for NH_3 sensing. The thin films were characterized by scanning electron microscope(SEM), Fourier transform infrared spectroscopy(FTIR) and ultraviolet-visible spectroscopy(UV-VIS) to investigate the morphologies and the composition contents, respectively. The experimental results reveal that PVP/GO based sensor holds higher sensitivity, larger responsiveness and smaller baseline drift than those based on pure PVP at room temperature. Besides, the prepared sensor exhibits greater response to NH_3 than other gases such as CO, CO_2 and NO_2 at the same concentration. The good linearity, reproducibility and stability demonstrate the practicability of PVP/GO hybrid film in detecting NH_3.展开更多
Ammonia （NH3） is a toxic gas released in different industrial, agricultural and natural processes. It is also a biomarker for some diseases. These require NH3 sensors for health and safety reasons. To boost the sens...Ammonia （NH3） is a toxic gas released in different industrial, agricultural and natural processes. It is also a biomarker for some diseases. These require NH3 sensors for health and safety reasons. To boost the sensitiv- ity of solid-state sensors, the effective sensing area should be increased. Two methods are explored and compared using an evaporating pool of 0.5 mL NH4OH （28% NH3）. In the first method an array of Si nanowires （Si NWA） is obtained via metal-assisted-electrochemical etching to increase the effective surface area. In the second method CVD graphene is suspended on top of the Si nanowires to act as a sensing layer. Both the effective surface area as well as the density of surface traps influences the amplitude of the response. The effective surface area of Si NWAs is 100 × larger than that of suspended graphene for the same top surface area, leading to a larger response in amp- litude by a factor of -7 notwithstanding a higher trap density in suspended graphene. The use of Si NWAs in- creases the response rate for both Si NWAs as well as the suspended graphene due to more effective NH3 diffu- sion processes.展开更多
基金supported by the Funds for Creative Research Groups of China(Grant No.61421002)the National Natural Science Foundation of China(Grant No.61571097)
文摘In this paper, composite film based on polyvinylpyrrolidone(PVP)/graphene oxide(GO) was fabricated by spray method on AT-cut 9.986 MHz quartz crystal microbalance(QCM) for NH_3 sensing. The thin films were characterized by scanning electron microscope(SEM), Fourier transform infrared spectroscopy(FTIR) and ultraviolet-visible spectroscopy(UV-VIS) to investigate the morphologies and the composition contents, respectively. The experimental results reveal that PVP/GO based sensor holds higher sensitivity, larger responsiveness and smaller baseline drift than those based on pure PVP at room temperature. Besides, the prepared sensor exhibits greater response to NH_3 than other gases such as CO, CO_2 and NO_2 at the same concentration. The good linearity, reproducibility and stability demonstrate the practicability of PVP/GO hybrid film in detecting NH_3.
基金financial support of EPSRC via the EEE department
文摘Ammonia （NH3） is a toxic gas released in different industrial, agricultural and natural processes. It is also a biomarker for some diseases. These require NH3 sensors for health and safety reasons. To boost the sensitiv- ity of solid-state sensors, the effective sensing area should be increased. Two methods are explored and compared using an evaporating pool of 0.5 mL NH4OH （28% NH3）. In the first method an array of Si nanowires （Si NWA） is obtained via metal-assisted-electrochemical etching to increase the effective surface area. In the second method CVD graphene is suspended on top of the Si nanowires to act as a sensing layer. Both the effective surface area as well as the density of surface traps influences the amplitude of the response. The effective surface area of Si NWAs is 100 × larger than that of suspended graphene for the same top surface area, leading to a larger response in amp- litude by a factor of -7 notwithstanding a higher trap density in suspended graphene. The use of Si NWAs in- creases the response rate for both Si NWAs as well as the suspended graphene due to more effective NH3 diffu- sion processes.
