We report the measurement of total molybdenum ion density for L-mode and H-mode plasmas on EAST using spectral lines observation and calculation based on an impurity transport code.A flat-filed extreme ultraviolet spe...We report the measurement of total molybdenum ion density for L-mode and H-mode plasmas on EAST using spectral lines observation and calculation based on an impurity transport code.A flat-filed extreme ultraviolet spectrometer with some spatial resolution is used to obtain the radial profiles of molybdenum spectral line emissions.The absolute calibration for the extreme ultraviolet spectrometer is finished by comparing the calculated bremsstrahlung intensity with the readings of CCD detector.Molybdenum ion transport study is performed using the radial ion density profiles and one-dimensional impurity transport code STRAHL.The total molybdenum density profiles are determined from the transport analysis.The molybdenum density during L-mode and H-mode phases are obtained,which are about 3 and 4 orders of magnitude smaller than the electron density,respectively.An inward pinch is found during the H-mode phase that leads to the peaked profile of molybdenum density.展开更多
Lithium Beam Emission Spectroscopy systems in the outer midplane and divertor Langmuir probe arrays embedded in the divertor target plates,are utilized to investigate the scrape-off layer(SOL)blob transition and its r...Lithium Beam Emission Spectroscopy systems in the outer midplane and divertor Langmuir probe arrays embedded in the divertor target plates,are utilized to investigate the scrape-off layer(SOL)blob transition and its relation with divertor detachment on EAST.The blob transition in the near SOL is observed during the density ramp-up phase.When the plasma density,normalized to the Greenwald density limit,exceeds a threshold of f_(GW)~0.5,the blob size and lifetime increases by 2–3 times,while the blob detection rate decreases by about 2 times.In addition,a weak density shoulder is observed in the near SOL region at the same density threshold.Further analysis indicates that the divertor detachment is highly correlated with the blob transition,and the density threshold of blob transition is consistent with that of the access to the outer divertor detachment.The potential physical mechanisms are discussed.These results could be useful for the understanding of plasma-wall interaction issues in future devices that will operate under a detached divertor and high density conditions(over the blob transition threshold).展开更多
This paper presents the characteristics of L-mode detachment,together with the behavior of edge turbulent transport and plasma confinement on the HL-2A tokamak.Partially detached and pronounced detached states have be...This paper presents the characteristics of L-mode detachment,together with the behavior of edge turbulent transport and plasma confinement on the HL-2A tokamak.Partially detached and pronounced detached states have been achieved in L-mode plasma.Stored energy was maintained before and after detachment.Edge turbulence and its transport have increased obviously in the partially detached state.In the pronounced detached state,redistribution of the density and temperature profiles due to detachment leads to low amplitude of electron temperature and pressure,as well as very weak edge turbulence and transport.Despite strong plasma radiation in the pronounced detached state,reduced edge turbulent transport contributes to maintaining stored energy in detached L-mode plasma in HL-2A.Different detachment states play an important role in the redistribution of density and temperature profiles,which requires further study.展开更多
Anomalous ion heat transport is analyzed in the T-10 tokamak plasma heated with electron cyclotron resonance heating(ECRH) in second-harmonic extra-ordinary mode. Predictive modeling with empirical scaling for Ohmical...Anomalous ion heat transport is analyzed in the T-10 tokamak plasma heated with electron cyclotron resonance heating(ECRH) in second-harmonic extra-ordinary mode. Predictive modeling with empirical scaling for Ohmical heat conductivity shows that in ECRH plasmas the calculated ion temperature could be overestimated, so an increase of anomalous ion heat transport is required. To study this effect two scans are presented: over the EC resonance position and over the ECRH power. The EC resonance position varies from the high-field side to the low-field side by variation of the toroidal magnetic field. The scan over the heating power is presented with on-axis and mixed ECRH regimes. Discharges with high anomalous ion heat transport are obtained in all considered regimes. In these discharges the power balance ion heat conductivity exceeds the neoclassical level by up to 10 times. The high ion heat transport regimes are distinguished by three parameters: the ratio Te/Ti, the normalized electron density gradient R/■, and the ion–ion collisionality νii~*. The combination of high Te/Ti, high νii~*, and R/■=6-10 results in values of normalized anomalous ion heat fluxes up to 10 times higher than in the low transport scenario.展开更多
基金National Key Research and Development Program of China(Grant No.2017YFE031300)the Key Program of Research and Development of Hefei Science Center of China(Grant No.2017HSC-KPRD002)+4 种基金the National Natural Science Foundation of China(Grant No.11805231)the Natural Science Foundation of Anhui Province of China(Grant Nos.1908085J01,1808085QA14,and 1908085QF274)the ASIPP Science and Research Fund of China(Grant No.DSJJ-17-03)Collaborative Innovation Program of Hefei Science Center,CAS(Grant No.2019HSC-CIP005)Anqing Normal University Research Project,China(Grant Nos.043-180079 and 044-140001000024).
文摘We report the measurement of total molybdenum ion density for L-mode and H-mode plasmas on EAST using spectral lines observation and calculation based on an impurity transport code.A flat-filed extreme ultraviolet spectrometer with some spatial resolution is used to obtain the radial profiles of molybdenum spectral line emissions.The absolute calibration for the extreme ultraviolet spectrometer is finished by comparing the calculated bremsstrahlung intensity with the readings of CCD detector.Molybdenum ion transport study is performed using the radial ion density profiles and one-dimensional impurity transport code STRAHL.The total molybdenum density profiles are determined from the transport analysis.The molybdenum density during L-mode and H-mode phases are obtained,which are about 3 and 4 orders of magnitude smaller than the electron density,respectively.An inward pinch is found during the H-mode phase that leads to the peaked profile of molybdenum density.
基金supported by the National Key R&D Program of China(Nos.2017YFE0301300,2017YFA0402500,2019YFE03030000)Institute of Energy,Hefei Comprehensive National Science Center(Nos.GXXT2020004,12105187)+2 种基金National Natural Science Foundation of China(Nos.11922513,U19A20113,11905255,12005004)Anhui Provincial Natural Science Foundation(No.2008085QA38)China Postdoctoral Science Foundation(No.2021M702245)。
文摘Lithium Beam Emission Spectroscopy systems in the outer midplane and divertor Langmuir probe arrays embedded in the divertor target plates,are utilized to investigate the scrape-off layer(SOL)blob transition and its relation with divertor detachment on EAST.The blob transition in the near SOL is observed during the density ramp-up phase.When the plasma density,normalized to the Greenwald density limit,exceeds a threshold of f_(GW)~0.5,the blob size and lifetime increases by 2–3 times,while the blob detection rate decreases by about 2 times.In addition,a weak density shoulder is observed in the near SOL region at the same density threshold.Further analysis indicates that the divertor detachment is highly correlated with the blob transition,and the density threshold of blob transition is consistent with that of the access to the outer divertor detachment.The potential physical mechanisms are discussed.These results could be useful for the understanding of plasma-wall interaction issues in future devices that will operate under a detached divertor and high density conditions(over the blob transition threshold).
基金National Key Research and Development Program of China(Nos.2018YFE0303102,2018YFE0309103,2017YFE0300405 and 2017YFE0301203)National Natural Science Foundation of China(Nos.U1867222,11875124,11905051,11805055 and 11875020)Sichuan Youth Science and Technology Innovation Team Project(No.2020JDTD0030)。
文摘This paper presents the characteristics of L-mode detachment,together with the behavior of edge turbulent transport and plasma confinement on the HL-2A tokamak.Partially detached and pronounced detached states have been achieved in L-mode plasma.Stored energy was maintained before and after detachment.Edge turbulence and its transport have increased obviously in the partially detached state.In the pronounced detached state,redistribution of the density and temperature profiles due to detachment leads to low amplitude of electron temperature and pressure,as well as very weak edge turbulence and transport.Despite strong plasma radiation in the pronounced detached state,reduced edge turbulent transport contributes to maintaining stored energy in detached L-mode plasma in HL-2A.Different detachment states play an important role in the redistribution of density and temperature profiles,which requires further study.
文摘Anomalous ion heat transport is analyzed in the T-10 tokamak plasma heated with electron cyclotron resonance heating(ECRH) in second-harmonic extra-ordinary mode. Predictive modeling with empirical scaling for Ohmical heat conductivity shows that in ECRH plasmas the calculated ion temperature could be overestimated, so an increase of anomalous ion heat transport is required. To study this effect two scans are presented: over the EC resonance position and over the ECRH power. The EC resonance position varies from the high-field side to the low-field side by variation of the toroidal magnetic field. The scan over the heating power is presented with on-axis and mixed ECRH regimes. Discharges with high anomalous ion heat transport are obtained in all considered regimes. In these discharges the power balance ion heat conductivity exceeds the neoclassical level by up to 10 times. The high ion heat transport regimes are distinguished by three parameters: the ratio Te/Ti, the normalized electron density gradient R/■, and the ion–ion collisionality νii~*. The combination of high Te/Ti, high νii~*, and R/■=6-10 results in values of normalized anomalous ion heat fluxes up to 10 times higher than in the low transport scenario.
