The failure of mechanical components is mainly caused by three key mechanisms:wear,corrosion,and fatigue.Among these failure modes,wear of mechanical components notably increases energy consumption and leads to substa...The failure of mechanical components is mainly caused by three key mechanisms:wear,corrosion,and fatigue.Among these failure modes,wear of mechanical components notably increases energy consumption and leads to substantial economic losses.Fe-Cr-C-B-Ti-Y wear-resistant cladding metals were prepared by the plasma cladding method.The wear performance of the cladding metals was analyzed using an MLS-23 rubber wheel wet sand wear tester.X-ray diffraction,scanning electron microscope,electron backscatter diffraction,and transmission electron microscope were employed to investigate the phase composition and microstructure of the cladding metals,followed by a discussion of their strengthening and wear mechanisms.The results indicate that the microstructure of Fe-Cr-C-B-Ti-Y cladding metals is composed of austeniteγ-Fe,M_(23)(C,B)_(6)eutectic carbide,and TiC hard phase.As the Y_(2)O_(3)content increases,the hardness and wear resistance of the cladding metal show a trend of first increasing and then decreasing.When the Y_(2)O_(3)content is 0.4wt%,the precipitation of TiC hard phase and M_(23)(C,B)_(6)-type eutectic carbides reaches maximum,and the grain size is the finest.The cladding metal exhibits optimal formability,featuring the smallest wetting angle of 52.2°.Under this condition,the Rockwell hardness value of the cladding metal is 89.7 HRC,and the wear mass loss is 0.27 g.The dominant wear mechanism of cladding metals is abrasive wear,and the material removal process involves micro-cutting and plowing.展开更多
设计并合成了一种交叉共轭的(cross-conjugated)缺电子型聚合物单体——二溴代噻吩[2,3-b]并噻吩-吡咯[3,4-c]并吡咯(DPPTTZ)二酮,并将其分别与噻吩(T)、硒吩(Se)和N-甲基吡咯(Py)的双锡试剂进行共聚反应,获得了一类新的供体-受体(D-A)...设计并合成了一种交叉共轭的(cross-conjugated)缺电子型聚合物单体——二溴代噻吩[2,3-b]并噻吩-吡咯[3,4-c]并吡咯(DPPTTZ)二酮,并将其分别与噻吩(T)、硒吩(Se)和N-甲基吡咯(Py)的双锡试剂进行共聚反应,获得了一类新的供体-受体(D-A)型共轭聚合物光电材料.这类材料分子的最高占有轨道(HOMO)能级较低,因此其光电器件具有较高的开路电压(Voc),稳定性好.此外,它们在紫外-可见光区有较宽的吸收,最大吸收位于波长620 nm附近;能带隙(band gap)小,分别为1.86 e V(p DPPTTZ-T)、1.83 e V(p DPPTTZ-Se)和1.85 e V(p DPPTTZ-Py).器件初步测试结果表明,上述聚合物与PC71BM组成的本体异质结聚合物太阳能电池Voc在0.68~0.81 V之间,能量转化效率(PCE)最高达3.05%(p DPPTTZ-T).展开更多
In order to search a effective therapy for viral myocarditis, antivial activity of Rheum officinale on Coxsackieivirus B 3 (CVB 3) was evaluated in BALB/C mice. After being determined optium scheme with orthogonal des...In order to search a effective therapy for viral myocarditis, antivial activity of Rheum officinale on Coxsackieivirus B 3 (CVB 3) was evaluated in BALB/C mice. After being determined optium scheme with orthogonal design, mice infected with CVB 3 were treated with Rheum officinale , ribavirin and 0.9% NaCl. The survival rates of the mice were 35%,5% and 5%;Median survival time were 23,11 and 10.5 days;Infectious viral titers were 10 -3.2 ,10 -4.7 and 10 -4.7 TCID 50 / 0.1 mL repectively, The lesions of cardiac tissues lightened in mice treated with Rheum offinicale . These results showed that Rheum officinale was effective in treatment of CVB 3 infected mice. The study provided scientific basis for further research and widen antiviral spectrum of Rheum officinale .展开更多
文摘The failure of mechanical components is mainly caused by three key mechanisms:wear,corrosion,and fatigue.Among these failure modes,wear of mechanical components notably increases energy consumption and leads to substantial economic losses.Fe-Cr-C-B-Ti-Y wear-resistant cladding metals were prepared by the plasma cladding method.The wear performance of the cladding metals was analyzed using an MLS-23 rubber wheel wet sand wear tester.X-ray diffraction,scanning electron microscope,electron backscatter diffraction,and transmission electron microscope were employed to investigate the phase composition and microstructure of the cladding metals,followed by a discussion of their strengthening and wear mechanisms.The results indicate that the microstructure of Fe-Cr-C-B-Ti-Y cladding metals is composed of austeniteγ-Fe,M_(23)(C,B)_(6)eutectic carbide,and TiC hard phase.As the Y_(2)O_(3)content increases,the hardness and wear resistance of the cladding metal show a trend of first increasing and then decreasing.When the Y_(2)O_(3)content is 0.4wt%,the precipitation of TiC hard phase and M_(23)(C,B)_(6)-type eutectic carbides reaches maximum,and the grain size is the finest.The cladding metal exhibits optimal formability,featuring the smallest wetting angle of 52.2°.Under this condition,the Rockwell hardness value of the cladding metal is 89.7 HRC,and the wear mass loss is 0.27 g.The dominant wear mechanism of cladding metals is abrasive wear,and the material removal process involves micro-cutting and plowing.
文摘设计并合成了一种交叉共轭的(cross-conjugated)缺电子型聚合物单体——二溴代噻吩[2,3-b]并噻吩-吡咯[3,4-c]并吡咯(DPPTTZ)二酮,并将其分别与噻吩(T)、硒吩(Se)和N-甲基吡咯(Py)的双锡试剂进行共聚反应,获得了一类新的供体-受体(D-A)型共轭聚合物光电材料.这类材料分子的最高占有轨道(HOMO)能级较低,因此其光电器件具有较高的开路电压(Voc),稳定性好.此外,它们在紫外-可见光区有较宽的吸收,最大吸收位于波长620 nm附近;能带隙(band gap)小,分别为1.86 e V(p DPPTTZ-T)、1.83 e V(p DPPTTZ-Se)和1.85 e V(p DPPTTZ-Py).器件初步测试结果表明,上述聚合物与PC71BM组成的本体异质结聚合物太阳能电池Voc在0.68~0.81 V之间,能量转化效率(PCE)最高达3.05%(p DPPTTZ-T).
文摘In order to search a effective therapy for viral myocarditis, antivial activity of Rheum officinale on Coxsackieivirus B 3 (CVB 3) was evaluated in BALB/C mice. After being determined optium scheme with orthogonal design, mice infected with CVB 3 were treated with Rheum officinale , ribavirin and 0.9% NaCl. The survival rates of the mice were 35%,5% and 5%;Median survival time were 23,11 and 10.5 days;Infectious viral titers were 10 -3.2 ,10 -4.7 and 10 -4.7 TCID 50 / 0.1 mL repectively, The lesions of cardiac tissues lightened in mice treated with Rheum offinicale . These results showed that Rheum officinale was effective in treatment of CVB 3 infected mice. The study provided scientific basis for further research and widen antiviral spectrum of Rheum officinale .
