摘要
本文对簿壁波导弯头件的液态模锻成形进行了研究。研究结果表明:液态模锻波导弯头件的尺寸精度在0.02mm～0.04mm之内,满足波导器件的标准化、积木化、组合化和稳定化的要求。采用该项新技术,可以提高材料的利用率和生产效率,降低成本。
Liquid forging processing to thin wall waveguide angle head has been experimentally studied. The results show that the dimensional tolerance of waveguide angle head by liquid forging processing are 0.02- 0.04mm, it meets the requirements of standardization, building block system, built-up type and stability to waveguide parts. This new technology can increase high percentage of stock utilization and productivity efficiency, and lower cost.
出处
《北京科技大学学报》
EI
CAS
CSCD
北大核心
1993年第3期281-286,共6页
Journal of University of Science and Technology Beijing
关键词
液态模锻
薄壁件
波导弯头
liquid forging- thin wall piece, waveguide angle head
