期刊文献+

微细板翅结构强化对流换热实验研究 被引量:3

EXPERIMENTAL RESEARCH ON HEAT TRANSFER ENHANCEMENT IN A MINI-FIN STRUCTURE
在线阅读 下载PDF
导出
摘要 本文对水和空气流过紫铜微细板翅结构构中的对流换热进行行实验研究,并与相近孔隙率的烧结多孔介质中的对流换热进行比较。结果表明:在本文实验参数范周内,与空槽道相比,该微细板翅结构使水的对流换热增强9倍以上,使空气的对流换热增强了15-30倍;与相近孔隙率的锡青铜烧结多孔结构相比,该微细板翅结构中的流动阻力大大减小,而对流换热能力却增强。 Forced convection heat transfer of air and water in a pure copper mini-fin structure was investigated experimentally. The results show that the convection heat transfer coefficient can be increased more than 9 times for water and 15-30 times for air in the mini-fin structure compared with the bare plate channel for the conditions in the present research. The flow resistance for water and air flowing through the mini-fin structure was less, while heat transfer coefficient was higher than in the sintered bronze porous structure.
出处 《工程热物理学报》 EI CAS CSCD 北大核心 2003年第3期484-486,共3页 Journal of Engineering Thermophysics
基金 国家杰出青年科学基金资助项目(No.50025617) 国家重点基础研究发展计划资助项目(No.G1999033106)
关键词 微细板翅 实验研究 对流换热 rnini-fin structure experimental research convection heat transfer
  • 相关文献

参考文献2

  • 1吕晓辰 姜培学 任泽霈 等.微型电阻电火箭中传热问题初步数值模拟[A]..见:中国工程热物理学会第十届年会论文集传热传质学(下册)[C].济南,2001.757-761.
  • 2李勐.多孔介质中对流换热的数值模拟和实验研究: [硕士论文].北京:清华大学热能工程系,2002.

同被引文献24

  • 1汤勇,夏伟,曾志新,刘树道,叶帮彦.Fin formation model during pre-roll ploughing of copper 3D outside fin tube[J].中国有色金属学会会刊:英文版,2001,11(5):712-716. 被引量:15
  • 2姜培学,王补宣,任泽.微尺度换热器的研究及相关问题的探讨[J].工程热物理学报,1996,17(3):328-332. 被引量:23
  • 3顾维藻 神家锐 马重芳 等.强化换热[M].北京:科学出版社,1990..
  • 4WM凯斯 A L 伦敦.紧凑式热交换器[M].北京:科学出版社,1997..
  • 5YAZAWA K, BAR-COHEN A. Energy efficient cooling of notebook computers [A]. 2002 Inter Society Conference on Thermal Phenomena [C]. San Diego, CA: Institute of Electrical and Electronics Engineering Inc, 2002: 785-791.
  • 6ZHANG H Y, PINJALA D, NAVAS O K, CHAN P K, LIU X P,HAYASHI H, HAN J B. Development of thermal solutions for high performance laptop computers [A]. 2002 Inter Society Conference on Thermal Phenomena [C]. San Diego, CA: Institute of Electrical and Electronics Engineering Inc, 2002: 433-440.
  • 7IM Y, CHO H, KIM M, PAEK J. Micro cooling application on high density memory module [A]. 19th IEEE SEMI-THERM Symposium[C]. San Jose, CA: Institute of Electrical and Electronics Engineering Inc, 2003: 179-184.
  • 8AVENAS Y, GILLOT C, BRICARD A, SCHEAFFER C. On the use of flat heat pipes as thermal spreaders in power electronics cooling[A]. 2002 IEEE 33rd Annual [C]. Cairns, Australia: Institute of Electrical and Electronics Engineering Inc,2002: 753-757.
  • 9WUTTIJUMNONG V, NGUYEN T, MOCHIZUKI M, MASHIKOK, SAITO Y, NGUYEN T. Overview latest technologies using heat pipe and vapor chamber for cooling of high heat generation notebook computer [A]. 20th IEEE SEMI-THERM Symposium [C]. San Jose,CA: Institute of Electrical and Electronics Engineering Inc, 2004:221-224.
  • 10JOSHI Y. Emerging Thermal Challenges in Electronics Driven by Performance, Reliability and Energy Efficiency. Therminic 2002.

引证文献3

二级引证文献13

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部