期刊文献+

斜流工况下泵喷推进器推进性能数值分析 被引量:5

Numberical Simulation of Propulsion Performance of a Pump-Jet Propulsor in Oblique Flow
原文传递
导出
摘要 斜流入水的现象在推进器的运行过程中广泛存在,会对推进器的水动力性能造成不利影响。为了分析斜流工况对泵喷推进器推进效率及流场造成的影响,采用分块网格技术,对泵喷推进器内外流场进行了结构化网格划分。基于RANS方程,SST k-ω湍流模型,对不同转速(n=3000,3600,4200r/min)、不同斜流角(β=0°,5°,10°,15°,20°,25°,30°,40°)的泵喷推进器进行了数值模拟。数值模拟方法通过Ka4-70/19A导管桨进行了验证,计算值与实验值吻合情况良好。研究结果表明:小角度下,斜流角的改变对泵喷推进器的效率影响很小;斜流角>20°时,斜流角增大将使推进效率明显减少,这是由于泵喷推进器内流场分布不均,出现了水流聚集区和分散区,降低了泵喷推进器的平衡性以及对流体的加速效果;斜流角越大,叶尖间隙对主流影响越大,造成的能量损失越大。 The phenomenon of oblique inflow is widespread in the operation of the propeller,which will adversely affect the hydrodynamic performance of the propeller.In order to analyze the effects of oblique flow on the propulsion efficiency and flow field of the pump-jet propulsor,multi-block was adopted to create the grid of all computation domain in a pump-jet propulsor.The method based on RANS equation and the SST k-ωturbulence model were adopted to study the hydrodynamic performance of a pump-jet propulsor in different rotation speed(n=3000,3600,4200 r/min)and different oblique inflow angles(β=0°,5°,10°,15°,20°,25°,30°,40°).The numberical simulation method was verified by duct propeller Ka4-70 with duct 19 A and the calculated values were in good agreement with the experimental values.The results show that the propulsion efficiency changes tinily in little oblique angle and decreases significantly in oblique angle larger than 20°.This is because the distribution of the flow in pump-jet propulsor is uneven,and the concentration area and dispersion area appear,which decrease the balance of pump-jet propulsor and acceleration performance of the pump jet.Furthermore,the influence of tip clearance on the main flow increaces in larger oblique angle,and it also leads to the greater energy loss.
作者 王辰 鹿麟 WANG Chen;LU Lin(College of Mechatronic Engineering,North University of China,Taiyuan 030051,China)
出处 《推进技术》 EI CAS CSCD 北大核心 2020年第11期2596-2604,共9页 Journal of Propulsion Technology
基金 山西省自然科学基金(201801D221038) 山西省回国留学人员科研资助项目(2020-106) 山西省研究生教育创新项目(2020SY343)。
关键词 泵喷推进器 推进性能 计算流体力学 斜流 数值模拟 Pump-jet propulsor Propulsion performance Computational fluid dynamics Oblique flow Numerical simulation
  • 相关文献

参考文献4

二级参考文献30

  • 1丁江明.船舶喷水推进器推进性能预报研究[D].武汉:海军工程大学,2009.
  • 2Suryanarayana Ch, Satyanarayana B, Ramji K, etal. Experimental evaluation of pumpjet propulsor for an axisymmetric body in wind tunnel[J]. International Journal of Naval Architecture and Ocean Engineering, 2010, 2(1) :24-33.
  • 3Suryanarayana Ch, Satyanarayana B, Ramji K. Per- formance evaluation of an underwater body and pumpjet by model testing in cavitation tunnel[J]. In-ternational Journal of Naval Architecture and Ocean En- gineering, 2010, 2(2):57-67.
  • 4ALLSION J. Marine waterjet propulsion [ J ]. SNAME Transaction, 1993,101 : 275-335.
  • 5NORBERT B. Numerical analysis of a waterjet propul- sion system[D]. Netherlands: Library Eindhoven Uni- versity of Technology, 2006.
  • 6PEIXIN H, ZANGENEH M. CFD simulation of the flow through a waterjet pump [ C ]//International Conference on Waterjet propulsion3. Gothenburg : RINA ,2001.
  • 7PARVIZ G, ROYA S, MAHDI Y. Performance assess- ment of the waterjet propulsion system through a com- bined analytical and numerical approach [ J ]. Interna- tional Journal of Physics, 2013 ( 2), 22-27.
  • 8AKIRA Goto, ZENGENEH M. Hydrodynamic design of pump diffuser using inverse design method and CFD [ J ]. Journal of Fluids Engineering, 2002,124 : 319-328.
  • 9SVENSSON R, GROSSI L. Trial result including wake measurements from the world's largest waterjet installa- tion[ C] //International Symposium on Waterjet Propul- sion II. Amsterdam : RINA. 1998.
  • 10Suryanarayana C, Satyanarayana B, Ramji K, et al. Experiment evaluation of pumpjet propulsor for an axisymmetric body in wind tunnel[J]. International Journal of Naval Architecture and Ocean Engineering, 2010(2): 24-33.

共引文献59

同被引文献21

引证文献5

二级引证文献11

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部