期刊文献+

基于金属掺杂ITO透明导电层的紫外LED制备 被引量:2

Fabrication of UV LEDs with Metal-doped ITO Transparent Conductive Layer
在线阅读 下载PDF
导出
摘要 为降低ITO薄膜对紫外波段的光吸收,制备低电压高功率的紫外LED,研究了一种基于金属掺杂ITO透明导电层的365nm紫外LED的制备工艺。利用1cm厚的石英片生长了不同厚度ITO薄膜以及在ITO上掺杂不同金属的新型薄膜,并研究了在不同的退火条件下这种薄膜的电阻和透过率,分析了掺杂金属ITO薄膜的带隙变化。将这种掺杂的ITO薄膜生长在365nm外延片上并完成电极生长,制备成14mil×28mil的正装LED芯片。利用电致发光(EL)设备对LED光电性能进行测试并对比。实验结果表明:掺Al金属的ITO薄膜能够相对ITO薄膜的带隙提高0.15eV。在600℃退火后,方块电阻降低6.2Ω/□,透过率在356nm处达到90.8%。在120mA注入电流下,365nmLED的电压降低0.3V,功率提高14.7%。ITO薄膜掺金属能够影响薄膜带隙,改变紫光LED光电性能。 In order to reduce the optical absorption of ITO thin films to UV waveband and to prepare low voltage as well as high power ultraviolet LEDs, the preparation process of 365 nm UV LED based on metal-doped ITO(Metal-ITO) transparent conductive layer was studied. The ITO thin films of different thickness and doped with different metals on ITO layer were grown by using 1 cm thickness quartz substrate, and the resistance and transmittance of the films were studied under different annealing conditions. The change of bandgap of Metal-ITO thin films was analyzed. Then, the Metal-ITO thin films were grown on 365 nm epitaxial wafers and completed the electrode growth, 14 mil×28 mil formal LEDs were prepared. Finally, the photoelectric properties of LED with Electroluminescence(EL) equipment were tested and compared. The experimental results show that the bandgap of Al-ITO thin film can be increased by 0.15 eV compared with that of ITO thin film. After annealing at 600℃, the square resistance is reduced by 6.2 Ω/□ and the transmittance is 90.8%. At 120 mA injection current, the decrease of voltage of 365 nm LED is 0.3 V and the increase of light output power is 14.7%. So, the Metal-ITO film can influence the bandgap of the film and along with the change of photoelectric performance of UV LED.
作者 文如莲 胡晓龙 高升 梁思炜 王洪 WEN Ru-lian;HU Xiao-long;GAO Sheng;LIANG Shi-wei;WANG Hong(Engineering Research Center for Optoelectronics of Guangdong Province,School of Physics and Optoelectronics,South China University of Technology,Guangzhou 510640,China;Guangzhou Institute of Modern Industrial Technology,Guangzhou 511458,China)
出处 《发光学报》 EI CAS CSCD 北大核心 2018年第12期1735-1742,共8页 Chinese Journal of Luminescence
基金 广东省科技计划(2015B010127013 2016B010123004 2017B010112003) 广州市科技计划(201504291502518 201604046021 201707010067) 国家自然科学基金(61404050)资助项目~~
关键词 ITO 掺金属 薄膜带隙 紫外LED ITO metal-dope fihn energy gap UV LED
  • 相关文献

参考文献5

二级参考文献47

  • 1王敏,蒙继龙.ITO薄膜的电学性能研究[J].广东技术师范学院学报,2004,25(4):72-74. 被引量:5
  • 2王明利,范正修.在未加热基底上反应共溅ITO薄膜的光电特性[J].光电工程,1994,21(4):52-57. 被引量:2
  • 3王军,成建波,饶海波,蒋亚东,杨刚.磁控溅射低阻ITO薄膜的气体参数优化[J].压电与声光,2007,29(1):115-117. 被引量:9
  • 4SUEVA D, GEORGIEV S S, NEDEV N, et al. A neutron detector based on an ITO/p-Si structure[J]. Vacuum, 2000, 58(2/3): 308-314.
  • 5TEIXEIRA V, CUI H N , MENG L J, et al. Amorphous ITO thin films prepared by DC sputtering for electrochromic applications [J]. Thin Solid Films, 2002, 420-421(2) : 70-75.
  • 6MENG Jianli, PLACIDO Frank. Annealing effect on ITO thin films prepared by microwave enhanced DC reactive magnetron sputtering for telecommunication applications [J]. Surface and Coatings Technology, 2003, 166(1): 44-50.
  • 7PARKSK, HANJ I, KIMWK, etal. Deposition of indium-tin-oxide films on polymer substrates for application in plastic-based flat panel displays[J]. Thin Solid Films, 2001, 397(1/2):49-55.
  • 8HERRERO J, GUILLEN C. Transparent films on polymers for photovoltaic applications[J]. Vaeuum, 2002, 67(3/4): 611-616.
  • 9LIU Enke, ZHU Binsheng, LUO Jinsheng. Semiconductor physics [M]. Beijing: Publishing House of Electronics Industry, 2003:111-118.
  • 10YOU D J, CHOI S K, HAN H S, et al. Effect of the deposition geometry on the electrical properties within tin doped indium oxide film deposited under a given RF magnetron[J]. Thin Solid Films, 2001, 401 (1/2): 229-234.

共引文献66

同被引文献8

引证文献2

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部