期刊文献+

吸附罐空隙率对天然气脱CO_2性能的影响 被引量:5

Effect of adsorption column porosity on removing CO_2 from natural gas
在线阅读 下载PDF
导出
摘要 为了研究海上天然气脱CO_2时因摇摆导致吸附罐空隙率变化对吸附净化效果的影响,搭建吸附实验台,利用实验数据,建立二维吸附净化模型,并验证了模型的有效性。结果表明:不流动吸附状态下,随着吸附罐空隙率的增加,吸附罐出口处的甲烷摩尔分数呈现上升趋势,且摩尔分数大于99%。同时空隙率范围在0.25~0.5之间,吸附罐内的吸附热随着空隙率的增大呈现上升趋势;流动吸附时,随着空隙率的增大,吸附罐内压降呈现下降趋势且下降剧烈。吸附罐空隙率为0.35时,吸附净化效果最佳。吸附罐内沿轴线方向吸附热呈现下降趋势,并且吸附罐空隙率越小,吸附热沿轴线方向下降越剧烈。本文的研究结果有助于海上天然气的开采,对天然气的快速发展具有十分重要的意义。 The porosity of adsorption column was changed due to the swing motion of the boat for the offshore natural gas production. To study the effect of adsorption column porosity on adsorption purification, an adsorption experimental apparatus was built. A two-dimensional adsorption purification model was established based on the experiment data, and the validity of the model was confirmed. Result shows that the mass fraction of CH4 at the exit of adsorption column rose to more than 0.99 mole fraction with the increase of adsorption column porosity at the static state. The adsorption heat in the adsorption column rose with the increase of adsorption column porosity. In the case of flowing adsorption, the pressure drop in the adsorption column decreased dramatically with the increase of adsorption column porosity. The best adsorption purification achieved when the adsorption column porosity was 0.35. Along the axis direction of the adsorption column, adsorption heat showed a downward trend, and decreased rapidly with the decrease of the adsorption column porosity. This study will help improve the production efficiency of offshore natural gas, and have a significant effect on the rapid development of natural gas.
出处 《化工进展》 EI CAS CSCD 北大核心 2017年第2期435-441,共7页 Chemical Industry and Engineering Progress
基金 国家自然科学基金(51306210 51304233) 大学生创新创业训练计划(20141168)项目
关键词 吸附罐 空隙率 多孔介质 吸附净化模型 天然气 adsorption column porosity porous media adsorption purification model natural gas
  • 相关文献

参考文献7

二级参考文献108

共引文献67

同被引文献41

引证文献5

二级引证文献17

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部