期刊文献+

原位复合EVOH-SO_3Li/SiO_2电纺锂离子电池隔膜的力、热学性能研究 被引量:1

Research on the Mechanical and Thermal Properties of EVOH-SO_3Li/SiO_2 Lithium-ion Battery Diaphragm
原文传递
导出
摘要 首先合成了EVOH-SO_3Li接枝聚合物,然后采用原位复合技术,使纳米SiO_2在EVOH-SO_3Li溶液中原位生成,最后静电纺丝制备了EVOH-SO_3Li/SiO_2复合隔膜。用拉伸强度来对锂离子电池隔膜的力学性性能进行表征,并且研究不同含量的SiO_2对力、热性能的影响。结果表明SiO_2含量为2%(wt)时,复合隔膜的拉伸强度为2.36MPa。复合隔膜的熔点、熔融焓、初始分解温度都有一定程度的提高。 Firstly the grafted EVOH-SO_3Li/SiO_2 solution was synthesized, and then the nano SiO_2 was produced in the solution by in-situ preparation. After that the EVOH-SO_3Li/SiO_2 composite diaphragm was prepared through electrostatic spinning. The mechanical properties of the lithium-ion battery diaphragm were characterized by tensile strength. The effects of different SiO_2 contents on the mechanical properties and thermal properties were studied. The results showed that the tensile strength of the diaphragm would be 2.36 MPa when the SiO_2 content was 2%(wt). The melting point, melting enthalpy and initial decomposition temperature of the composite diaphragm were all improved to some extent.
出处 《化学与粘合》 CAS 2016年第1期50-53,共4页 Chemistry and Adhesion
基金 黑龙江省大学生创新创业训练计划项目(编号:201410214035)
关键词 原位复合 静电纺丝 EVOH-SO3Li/SiO2 隔膜 In-situ composite electrostatic spinning EVOH-SO3Li/SiO2 diaphragm
  • 相关文献

参考文献4

二级参考文献88

  • 1程琥,杜洪彦,杨勇.新型锂电池用复合隔膜的制备及其电化学性能表征[J].电化学,2004,10(3):303-306. 被引量:18
  • 2李立,苑克国,张育川,胡塔光,王安邦,杨裕生.二次锂电池用PVDF-HFP/SiO_2复合聚合物隔膜的研究[J].北京化工大学学报(自然科学版),2006,33(2):55-58. 被引量:11
  • 3高昆,胡信国,伊廷锋,陈辉.聚偏氟乙烯电纺膜及其电化学性能的研究[J].高分子学报,2006,16(9):1050-1054. 被引量:9
  • 4Je Young Kim, et al. Preparation of micro-porous gel poly- mer for lithium ion polymer battery[J]. Electrochim Acta, 2004,50(2-3) : 363.
  • 5Zhou D Y, et al. Preparation and performances of porous polyacrylonitrile-methyl methacrylate membrane for lithiu- mion batteries[J]. J Power Sources, 2008,184(2) : 477.
  • 6Rao M M, et al. Preparation and performance analysis of PE-supported P (AN-co-MMA) gel polymer electrolyte for lithium ion battery application[J]. J Membrane Sci, 2008, 322(2) :314.
  • 7Zhang S S, Xu K, et al. Alkaline composite film as a sepa- rator for rechargeable lithium batteries [J]. J Solid State Eleetrochem, 2003,7(8) : 492.
  • 8Abraham K M, et al. Polymer electrolytes reinforced by cel- gard[J]. J Electrochem Soc, 1995,142(3) :683.
  • 9Yoo S H, Kim C K. Enhancement of the meltdown tempera- ture of a lithium ion battery separator via a nanocomposite coating[J]. Ind Eng Chem Res, 2009,48(22) : 9936.
  • 10Chung Y S, Yoo S H, et al. Enhancement of meltdown temperature of the polyethylene lithium-ion battery separator via surface coating with polymers having high thermal resis- tance[J]. Ind Eng Chem Res,2009,48(9):4346.

共引文献65

同被引文献5

引证文献1

二级引证文献2

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部