摘要
以CFD技术为基础,对比转速84.5的单级单吸离心泵正反转运行时内部流动进行三维定常全流场数值模拟,计算采用雷诺时均方程和标准k-ε湍流模型,压力和速度耦合采用SIMPLEC算法,研究离心泵双向运行在同一转速不同流量情况下轴向力的特性,分析离心泵在泵工况和透平工况下,盖板、叶片、内表面所产生的轴向力的变化情况,并说明其产生的原因,进一步研究泵工况及透平工况下总轴向力的变化趋势.模拟结果表明:随着流量的增大,泵工况下总轴向力逐渐减小,与经验公式变化趋势相吻合,透平工况下总轴向力逐渐增大,其原因还有待进一步研究.在各自的最优工况附近,透平工况的总轴向力是泵工况总轴向力的1.2倍左右;通过计算表明在透平工况下运行时,泵轴强度仍然满足使用要求.
Based on the CFD software,the 3-D steady full flow field numerical simulation of the internal flow for centrifugal pump with the specific speed of 84.5 in the positive and negative going motion condition is performed.The N-S equations and standard κ-ε turbulent model was used in numerical simulation.The SIMPLEC algorithm was used in pressure-speed coupling.The study is about the characteristic analysis of axial thrust for centrifugal pump＇s two-way operation with the same rotate speed and different flow.The variation of axial thrust in the position of cover,blade and inner surface for the centrifugal pump and turbine condition is analyzed,and the reasons for the axial thrust are also explained.The study of the variation tendency of total axial thrust in pump and turbine condition is also performed.The results shown that with the flow increasing,the total axial thrust in pump condition decreases gradually,this is the same with the empirical formula; but the total axial thrust increases gradually with the flow increasing.Nearby the optimal condition,the total axial thrust in turbine condition is about 1.2 times with the one in pump conditior.In the turbine working operation,pump shaft strength still meets the requirement.
出处
《兰州理工大学学报》
CAS
北大核心
2014年第1期41-45,共5页
Journal of Lanzhou University of Technology
基金
国家自然科学基金(51169010)
"十二.五"国家计划资助项目(2012BAA08B05)
关键词
离心泵
双向运行
全流场
轴向力
centrifugal pump
two-way operation
full flow field
axial thrust
