期刊文献+

自交联型水基丙烯酸酯胶粘剂的合成与性能研究 被引量:2

Study on preparation and properties of water-based acrylate adhesive with self- crosslinking
原文传递
导出
摘要 以BA(丙烯酸丁酯)、MMA(甲基丙烯酸甲酯)、AA(丙烯酸)和HPA(丙烯酸羟丙酯)等作为主要单体,GMA(甲基丙烯酸缩水甘油酯)作为交联剂,采用半连续乳液聚合法制备了自交联型水基丙烯酸酯胶粘剂乳液,并将其应用于pvc(聚氯乙烯)/织物的粘接。研究结果表明:当m(软单体):m(硬单体)=5:5、州(复合乳化剂)=3%~4%、埘(引发剂)=1.0%和W(GMA)=4%(均相对于总单体质量而言)时,胶粘剂乳液的综合性能相对最好,其平均粒径为126.8nm、乳液稳定性良好、胶膜吸水率(4.23%)相对较低、耐热性相对较好目PVC/织物的剥离强度(28.3N/25mm)相对最大。 With BA (butyl acrylate), MMA (methyl methacrylate), AA (acrylic acid ) and HPA (hydroxypropyl acrylate) as main monomers, GMA (glycidyl methacrylate) as cross linker, a water-based acrylate adhesive emulsion with self-crosslinking, which emulsion was used for bonding between PVC (polyvinyl chloride ) and fabric ,was prepared by semi-continuous emulsion polymerization. The research results showed that the adhesive emulsion had the relatively best combination property because its average particle size was 126.8 nm,emulsion stability was good,water absorpsion(4.23%) of adhesive film was relatively lower,heat resistance was relatively better, and peel strength(28.3 N/25 ram) between PVC and fabric was relatively maximal when mass ratio of re(soft monomer):m(hard monomer) was 5:5,mass fractions of compound emulsifier,initiator and GMA were 3%-4%, 1.0% and 4% respectively in total monomers.
机构地区 陕西科技大学
出处 《中国胶粘剂》 CAS 北大核心 2013年第12期36-40,共5页 China Adhesives
基金 陕西省科学技术研究发展计划项目(2013KJXX-77)
关键词 丙烯酸酯 胶粘剂 自交联 甲基丙烯酸缩水甘油酯 聚氯乙烯 织物 acrylate adhesive self-crosslinking glycidyl methacrylate (GMA) polyvinyl chloride (PVC) fabric
  • 相关文献

参考文献12

二级参考文献53

共引文献40

同被引文献26

  • 1成航航,沈一丁,马国艳,杨凯,侯旭明.磷酸酯化苯丙共聚物乳液的合成及防锈性能[J].精细化工,2020,37(1):180-188. 被引量:9
  • 2Teng G H, Soucek M D, Yang X F, et al. Effect of the addition mode of cycloaliphatic diepoxide on the morpho- logy and film properties of crosslinkable coreshell latex[J]. Journal of Applied Polymer Science, 2003,88 (2) : 245-257.
  • 3Qu x w, Wang N Y, Lovell P A. Preparation and charac- terization of the latexes with different particle sizes by semibatch emulsion polymerization and the influence on properties of waterborne pressure-sensitive adhesives[J]. Journal of Applied Polymer Science, 2009, 112 (5) : 3030- 3040.
  • 4Kim J S, Choi W G, Cho K Y, et al.Effect of polyimide binder on electrochemical characteristics of surface- modified silicon anode for lithium ion batteries[J].Journal of Power Sources, 2013,244 : 521-526.
  • 5Prosini P P, Carewska M, Cento C, et al. Poly vinyl acetate used as a binder for the fabrication of a LiFeP04-based composite cathode for lithium-ion batteries[J]. E|ectro- chimica Acta,2014, 150: 129-135.
  • 6Tobing S D, Klein A. Molecular parameters and their relation to the adhesive performance of emulsion aeylie pressure-sensitive adhesives (11) : Effect of crosslinking[J]. Journal of Applied Polymer Science, 2001,79(ld) : 2558- 2564.
  • 7Meijer M D. Review on the durability of exterior wood coatings with reduced VOC-content[J].Progress in Organic Coatings, 2001,43(4) : 217-225.
  • 8Zhang Y C, Wang C Y, Tang X D. Cycling degradation of an automotive LiFePO4 lithium-ion battery[J]. Journal of Power Sources, 2011,196(3) : 1513-1520.
  • 9张光华,王义伟,朱军峰,崔萌.核壳型自交联聚丙烯酸酯乳液的成膜性能[J].高分子材料科学与工程,2009,25(1):71-74. 被引量:8
  • 10王华金,马建中,胡静,曹壮壮.核壳型聚丙烯酸酯复合乳液的性能研究[J].中国皮革,2010,39(1):11-15. 被引量:3

引证文献2

二级引证文献8

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部