摘要
针对线性分组码参数盲识别容错性能较差,以及在低误比特率且同步情况下利用分析矩阵秩亏法识别存在码长不足的问题,提出了一种基于二元高斯列消元法的分组码参数盲识别方法。首先将截获到的数据横向放入到分析矩阵,然后对分析矩阵的列进行二元域高斯消元,并计算每列所含"1"的比率值,再对所有比率值求均值和方差,在低误比特率且同步的情况下利用均值差值可确定码长,而在误比特率较高且不同步的情况下,则需利用方差差值来确定码长。理论分析和仿真表明:该方法与以往的矩阵模型识别方法相比,容错性能较好、计算量较低,且适用于各种码率的线性分组码的码长和同步识别。
In order to avoid fails of blind parameters identification for some particular low code rate linear block codes and improve the identification performance of common linear block codes,a blind identification approach based on binary column Gaussian elimination（BCGE） is proposed.Firstly,an intercepted sequence is put into an analysis matrix horizontally,then the rate of ＂1＂ involved in each column of the matrix after BCGE is computed.Finally the mean and variance of all the rates of ＂1＂ are calculated.In good conditions of synchronization with a very low error rate,the code length is estimated with means difference,in poor conditions of asynchronization with a high error rate,the code length is estimated with variances difference.Theoretical analysis and simulation shows the blind identification approach has a good fault-tolerant performance and can identify the code length and synchronization of linear block code of various code rates in low computation complexity.
出处
《系统工程与电子技术》
EI
CSCD
北大核心
2013年第7期1514-1519,共6页
Systems Engineering and Electronics
基金
国家自然科学基金(61071196
61102131)
重庆市杰出青年基金(CSTC2011jjjq40002)资助课题
关键词
线性分组码
码长识别
同步识别
二元高斯列消元法
linear block code
code length identification
synchronization identification
binary column Gaussian elimination
