摘要
以上海市某先入后出型匝道组合为例,利用校验后的仿真软件TSIS研究了匝道间距与交织区平均速度的变化关系。结果表明,随着匝道间距的增加,交织区平均速度呈先增加后趋于稳定的趋势,且匝道间距对主线最外侧车道的影响程度远远高于对内侧车道的影响。借助统计软件SPSS分析了主线设计速度分别为60、80、100 km/h时匝道间距、流量、汇入比、分流比与交织区平均速度的关系并建立了相应的定量模型。结果表明,主线设计速度不同时,影响交织区平均速度的因素也有所变化。根据定量模型分别计算了不同设计速度和交织区平均速度条件下的匝道间距,并根据实际情况对计算值进行了修正,最终给出了合理的推荐值,并与《城市快速路设计规程》(CJJ129—2009)中的推荐值进行了对比。结果表明,定量统计模型计算值较为合理,且更加详细,便于工程应用。
The relation between ramps＇ distance and average speed in weaving area is researched based on calibrated simulation software TSIS, taking certain on-off ramps in Shanghai urban freeway for example. The result shows that the average speed in weaving area increases with the increase of ramps＇ distance at first and finally trends towards stability, in which the most lateral lane is influenced most by ramps＇ distance. In addition, the relation of ramps＇ distance, traffic volume, rate of merging and rate of diversion with average speed in weaving area when the designed speed of the main road is 60, 80, 100 km/h respectively are analysed and the quantitative model is developed with statistical software SPSS. The result shows that the factors influencing average speed in weaving area vary with designed speed of the main road. Based on quantitative model, the ramp distance under different designed speeds and average speed in weaving area are calculated and adjusted according to practice. Finally, the recommended distance is presented and compared with the recommended values in Specification for Design of Urban Expressway （CJJ 129--2009 ）. The result shows that the values calculated by the quantitative statistical model are more reasonable, detailed, and convenient for practical use.
出处
《公路交通科技》
CAS
CSCD
北大核心
2013年第6期109-114,共6页
Journal of Highway and Transportation Research and Development
基金
国家自然科学基金项目(51078232/E0807)
关键词
交通工程
匝道最佳间距
统计建模
城市快速路
TSIS
交织区
traffic engineering
ramp optimal distance
statistical modeling
urban freeway
TSIS
weaving area
