期刊文献+

深冷处理对LC4铝合金热物理性能的影响 被引量:2

Effect of Cryogenic Treatment on Thermal Physical Properties of LC4 Al Alloy
原文传递
导出
摘要 利用电导仪和热膨胀仪测试了深冷处理前后LC4铝合金的电导率和热膨胀系数,并探讨了深冷处理对LC4铝合金热物理性能的影响。结果表明:深冷处理能降低退火LC4铝合金的电导率,改变热膨胀系数随温度的变化规律。当温度低于158.57℃时,深冷处理合金的热膨胀系数较相同温度下退火合金的高;高于158.57℃时,较退火合金的低。与深冷处理相比,LC4铝合金经深冷处理+时效后的电导率略有增大,但热膨胀系数随温度的变化规律变化不大。 The electrical conductivity and thermal expansion coefficient of LC4 aluminum alloy before and after cryogenic treatment were measured by electric conductivity instrument and thermal dilatometer, and the effects of cryogenic treatment on the thermal physical properties of LC4 aluminum alloy were studied. The results show that the cryogenic treatment can reduce the electrical conductivity of annealed LC4 aluminum alloy, and change the trend of the thermal expansion curve. At the same temperature, when the temperature is lower than 158.57 ℃, the thermal expansion coefficient of the alloy after cryogenic treatment is larger than that of annealed alloy, but is less than that of annealed alloy, when the temperature is higher than 158.57 ℃. Compared with cryogenic treatment, the electrical conductivity of the alloy after cryogenic treatment and aging treatment is large, but the change regularity of thermal expansion coefficient with temperature is not obvious.
作者 徐红
出处 《热加工工艺》 CSCD 北大核心 2013年第8期192-194,共3页 Hot Working Technology
关键词 LC4铝合金 深冷处理 电导率 热膨胀系数 LC4 aluminum alloy cryogenic treatment electrical conductivity thermal expansion coefficient
  • 相关文献

参考文献8

二级参考文献34

  • 1李海,郑子樵,王芝秀.含银7055铝合金回归再时效过程中的组织与性能变化[J].稀有金属材料与工程,2004,33(7):718-722. 被引量:14
  • 2李秀华,陈立佳,张凌云.超硬铝合金的微观组织和力学性能的研究[J].沈阳航空工业学院学报,2005,22(5):15-17. 被引量:6
  • 3赵祖德,王秋成,谢伟东,康凤,孟彬.7A04铝合金构件深冷处理过程瞬态温度场的数值模拟[J].低温工程,2007(2):21-23. 被引量:10
  • 4[1]Rensei F.Rensei Futatsuka development of copper alloy for leadframe [J].Journal of the Japan Copper and Brass Research Association,1997,36: 25-32.
  • 5[2]Naotsugu I.Behavor of pricipitation and recrystallization affect upon texture of Cu-Cr-Zr alloy [J].Journal of the Japan Copper and Brass Research Association,1993,32: 115-121.
  • 6[3]Motohisa M.High-strength and high-conductivity alloy KLF201 [J].Journal of the Japan Copper and Brass Research Association,1988,27: 93-98.
  • 7[4]Motohisa M.Development trends in new copper alloy for lead-frame [J].Journal of the Japan Copper and Brass Research Association,1990,29: 18-21.
  • 8[5]Motohisa M.Poformence of KFC-SH and KLF194-SHT copper alloys in high-strength and high-conductivity for lead frame [J].Journal of the Japan Copper and Brass Research Association,1990,29: 224-233.
  • 9[7]Hiroshi Y.Cu-Fe-Ti-Mg alloy used in electronical material [J].Journal of the Japan Copper and Brass Research Association,1984,23: 109-115.
  • 10[8]CEN Shu-chuan(陈树).Physical Property of Material(材料物理性能) [M].Shanghai: Shanghai Jiaotong University Press,1999.40.

共引文献173

同被引文献48

引证文献2

二级引证文献10

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部