摘要
对于凸缘筒型件的落料、拉伸和冲孔三序加工,通常采用分序或级进模工艺方法,本文采用复合模一副模具完成三序工作内容,收到了很好的效果,同时还介绍了三序复合模设计的注意事项。
It usually adopts points sequence or progressive die process method to flange cartridge type parts blanking drawing and piercing three-order processing. This article uses one set of compound die to complete three-sequence work content, receiving good effect. This article also introduces the matters needing attention of three-sequence.
出处
《模具制造》
2013年第3期9-11,共3页
Die & Mould Manufacture
关键词
落料
拉伸
冲孔
复合模
blanking
drawing
piercing
compound die
