期刊文献+

半球突开缝翅片传热特性模拟及(火积)分析 被引量:2

Entransy Analysis and Numerical Simulation on Heat Transfer Performance of Semi-Dimpled Split Fin
原文传递
导出
摘要 本文应用三维数值模拟对半球突开缝翅片的传热与流动特性进行研究,并利用(火积)耗散理论对其传热机理进行分析。计算结果表明:与平片相比,半球突开缝翅片的传热性能提高24.06%~67.73%,综合性能(k/f^(1/3))提高7.55%~23 88%,换热效果明显好于平片。通过(火积)耗散理论分析显示:半球突开缝翅片的等效热阻小,换热的不可逆程度较低,因而换热性能较好。 In this paper,the heat transfer and flow characteristics of semi-dimpled split fin are investigated by numerical simulation and the physical mechanism of heat transfer is analyzed by entransy dissipation principle.The computational results show that the heat transfer performance of semidimpled split fin can improve 24.06%~67.73%and the overall performance increases 7.55%~23.88% compared with the plain fin,which means that the enhanced heat transfer of semi-dimpled split fin is better than that of plain fin.By applying the entransy dissipation principle to analyze the fins, it's found that the equivalent thermal resistance of semi-dimpled split fin is smaller than that of plain fin,and the heat transfer irreversibility of semi-dimpled split fin is lower,so the heat transfer performance of semi-dimpled split fin is better.
出处 《工程热物理学报》 EI CAS CSCD 北大核心 2013年第1期153-156,共4页 Journal of Engineering Thermophysics
基金 国家自然科学基金(No.21076200) 河南省省院合作项目(No.092106000013) 河南省科技攻关项目(No.102102210138) 郑州市创新团队项目(No.10CXTD151) 郑州市科技攻关项目(No.10PTGG381-1)
关键词 半球突开缝翅片 强化换热 (火积)耗散 等效热阻 semi-dimpled split fin enhanced heat transfer entransy dissipation equivalent thermal resistance
  • 相关文献

参考文献8

  • 1Afanasyev V, Chudnovsky Y P, Leontiev A, et al. Turbu- lent Flow Friction and Heat Transfer Characteristics for Spherical Cavities on a Flat Plate [J]. Experimental Ther- mal and Fluid Science, 1993, 7(1): 1-8.
  • 2Mahmood G, Ligrani P. Heat Transfer in a Dimpled Chan- nel: Combined Influences of Aspect Ratio, Temperature Ratio, Reynolds Number and Flow Structure [J]. Interna- tional Journal of Heat and Mass Transfer, 2002, 45(10): 2011- 2020.
  • 3CHANG S W, CHIANG K F, YANG T L, et al. Heat Transfer and Pressure Drop in Dimpled Fin Channels [J]. Experimental Thermal and Fluid Science, 2008, 33(1): 23-40.
  • 4Isaev S A, Kornev N V, Leontiev A I, et al. Influence of the Reynolds Number and the Spherical Dimple Depth on Turbulent Heat Transfer and Hydraulic Loss in a Nar- row Channel [J]. International Journal of Heat and Mass Transfer, 2010, 53(1-3): 178-197.
  • 5樊菊芳,何雅铃,陶文铨.球突翅片表面的数值模拟和特性分析[J].工程热物理学报,2008,29(11):1921-1923. 被引量:7
  • 6Elyyan M A, Tafti D K. A Novel Split-Dimple Interrupted Fin Configuration for Heat Transfer Augmentation [J]. International Journal of Heat and Mass Transfer, 2009, 52(5/6): 1561 -1572.
  • 7GUO Z Y, ZHU H Y, LIANG X G. Entransy-a Phys- ical Quantity Describing Heat Transfer Ability [J]. In- ternational Journal of Heat and Mass Transfer, 2007, 50(13/14): 2545-2556.
  • 8CHEN Qun REN JianXun.Generalized thermal resistance for convective heat transfer and its relation to entransy dissipation[J].Chinese Science Bulletin,2008,53(23):3753-3761. 被引量:53

二级参考文献13

  • 1Belen'kiy M Ya, Gotovskiy M A, Lekh B M, et al. Heat Transfer Augumentation Using Surfaces Formed by a System of Spherical Cavities. Heat Transfer Research, 1993, 25:196-203.
  • 2Chen J. Muller-steinhagen H, Duffy G G. Heat Transfer Enhancement in Dimpled Tubes. Applied Thermal Engineering, 2001, 21:535-547.
  • 3Ko T H.A numerical study on entropy generation and optimization for laminar forced convection in a rectangular curved duct with longitu- dinal ribs[].International Journal of Thermal Sciences.2006
  • 4Erek A,Dincer I.An approach to entropy analysis of a latent heat storage module[].International Journal of Thermal Sciences.2008
  • 5Bergles A E.Heat transfer enhancement-the encouragement and accom-modation of high heat fluxes[].Journal of Heat Transfer.1997
  • 6Bejan A.Entropy Generation through Heat and Fluid Flow[]..1982
  • 7Saouli S,Aiboud-Saouli S.Second law analysis of laminar falling liquid film along an inclined heated plate[].Int Comm Heat Mass Tran.2004
  • 8Bergles E.Some perspectives on enhanced heat transfer-second-generation heat transfer technology[].Journal of Heat Transfer.1988
  • 9Bejan,A.A study of entropy generation in fundamental convective heat transfer[].ASME Journal of Heat Transfer.1979
  • 10P. K. Nag and P. Mukherjee.Thermodynamic optimization of convective heat transfer through a duct with constant wall temperature[].International Journal of Heat and Mass Transfer.1987

共引文献58

同被引文献29

  • 1Ligrani P, Mahmood G, Harrison J, et al. Flow structureand local nusselt number variations in a channel withdimples and protrusions on opposite walls [J]. Interna-tional Journal of Heat and Mass Transfer, 2001, 44(23): 4413.
  • 2Won S Y, Zhang Q, Ligrani P M. Comparisons of flowstructure above dimpled surfaces with different dimpledepths in a channel[J]. Physics of fluids,2005,17 ;45.
  • 3Chang S,Chiang K,Yang T,et al. Heat transfer and pres-sure drop in dimpled fin channels [J]. ExperimentalThermal and Fluid Science, 2008,33(1) :23.
  • 4Hwang S D,Kwon H G,Cho H H. Heat transfer with dim-ple/protrusion arrays in a rectangular duct with a lowreynolds number range[J]. International Journal of Heatand Fluid Flow,2008,29(4) : 916.
  • 5Hwang S D,Kwon H G,Cho H H. Local heat transfer andthermal performance on periodically dimple-protrusionpatterned walls for compact heat exchangers[J]. Energy,2010,35(12) : 5357.
  • 6Isaev S,Kornev N,Leontiev A, et al. Influence of thereynolds number and the spherical dimple depth on turbu-lent heat transfer and hydraulic loss in a narrow channel[J]. International Journal of Heat and Mass Transfer,2010,53(1) :178.
  • 7Chang S,Liou T M,Lee T H. Thermal performance com-parison between radially rotating ribbed parallelogramchannels with and without dimples[J]. International Jour-nal of Heat and Mass Transfer,2012,55( 13) :3541.
  • 8Mahmood G,Ligrani P. Heat transfer in a dimpled chan-nel: combined influences of aspect ratio, temperatureratio,reynolds number,and flow structure[J]. Internation-al Journal of Heat and Mass Transfer, 2002, 45(10): 2011.
  • 9Fan Q, Yin X. 3-D numerical study on the effect of geo-metrical parameters on thermal behavior of dimple jacketin thin-film evaporator [J]. Applied Thermal Engineering,2008,28(14) :1875.
  • 10Elyyan M A, Tafti D K. A novel split-dimple interruptedfin configuration for heat transfer augmentation [J]. Inter-national Journal of Heat and Mass "Transfer,2009,52(5):1561.

引证文献2

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部