期刊文献+

温度对玻璃纤维-环氧树脂润湿性的影响 被引量:2

Temperature influence on wettability of glass fiber-epoxy resin
在线阅读 下载PDF
导出
摘要 采用Wilhelmy法测定不同温度下CYD128环氧树脂的表面张力和环氧树脂浸润ST,ECT,TM玻璃纤维的动态接触角,计算玻璃纤维的表面自由能及环氧树脂浸润玻璃纤维的热力学黏附功,分析了玻璃纤维-环氧树脂润湿特性。结果表明:室温升至60℃,环氧树脂的黏度及表面张力降低,环氧树脂与玻璃纤维的热力学黏附功升高,玻璃纤维与环氧树脂的润湿性逐步改善;高于60℃后影响较小。 The surface tension of CYD128 epoxy resin and the dynamic contact angle of ST, ECT and TM glass fiber with CYD128 resin were measured by Wilhelmy method at different temperatures. The surface free energy of glass fiber and thermodynamic adhesion work of the resin impregnated fiber were calculated. The wetting properties of glass fiber and epoxy resin were investigated. The results indicate that: when the temperature increases to 60 ℃, the wettability between epoxy resin and glass fiber can be gradually improved by lowering the viscosity and surface tension of epoxy resin, and also by rising up the thermodynamics adhesion work of epoxy resin with glass fiber. When the temperature is above 60 ℃, the influence becomes weaker.
出处 《兵器材料科学与工程》 CSCD 北大核心 2012年第6期42-44,共3页 Ordnance Material Science and Engineering
基金 重庆市科技攻关计划资助项目(2010AA4051)
关键词 环氧树脂 玻璃纤维 表面张力 接触角 热力学黏附功 黏度 epoxy resin glass fiber surface tension contact angle thermodynamics adhesion work viscosity
  • 相关文献

参考文献3

二级参考文献41

  • 1黄根来,孙志杰,王明超,张佐光.玄武岩纤维及其复合材料基本力学性能实验研究[J].玻璃钢/复合材料,2006(1):24-27. 被引量:64
  • 2胡芳.单根纤维接触角测定技术及应用[J].造纸科学与技术,2006,25(1):34-36. 被引量:6
  • 3Amico S, Lekakou C. Mathematical modeling of capillary micro-flow through woven fabrics[J]. Composites Part A, 2000, 31(12):1331-1344.
  • 4Young W B, Wu S F. Permeabitity measurement of bidirectional woven glass fibers [J]. Journal of Reinforced Plastics and Composites, 1995, 14(10): 1109-1120.
  • 5Aranherri- Askargorta Ibon, Lampke Thomas, Bismarck Alexander. Wetting behavior of flax fibers as reinforcement for polypropylene[J]. Colloid and Interface Science. 2003, 263, 580-589.
  • 6Staples T L, Shaffer D G. Wicking flow in irregular capillaries [J]. Colloids and Surfaces A: Physicochemical and Engineering Aspects, 2002, 204(1/3): 239-250.
  • 7Ferrero F. Wettability measurements on plasma treated synthetic fabrics by capillary rise method[J]. Polymer Testing, 2003, 22(5): 571-578.
  • 8Nardin M, Schultz J. Relations Between work of adhesion and equilibrium interatomic distance at the interface [J]. Langmuir, 1996, 12(17):4238-4242.
  • 9Pisanova E, Mader E. Acid base interactions and covalent bonding at fiber-matrix interface: Contribution to the work of adhesion and measured adhesion strength[J]. Journal of Adhesion Science and Technology, 2000, 14(3) : 415-436.
  • 10Rankl M, Laib S, Seeger S. Surface tension properties of surface-coatings for application in biodiagnostics determined by contact angle measurements[J]. Colloids and Surfaces B: Biointerfaces, 2003, 30(3): 177-186.

共引文献48

同被引文献24

  • 1张培林,张佐光,李敏,孙志杰.液体在单向织物面内毛细浸润特性实验研究[J].复合材料学报,2006,23(4):9-14. 被引量:6
  • 2于淼,张华婷,郑世平.玻璃纤维表面偶联剂处理方法对树脂基复合材料性能的影响[J].宇航材料工艺,2006,36(6):29-31. 被引量:5
  • 3文思维,肖加余,曾竟成,江大志,杨孚标,张昌天.提高硼纤维/环氧复合材料界面抗剪强度的方法[J].机械工程材料,2007,31(6):38-41. 被引量:1
  • 4Cepeda-Jimenez C M, Ahlerliestcn R C, Ruano O A. Damage tolerance assessment by bend and shear tests of two muhilayer composites: glass fibre reinforced metal laminate and alumini- um roll-bonded laminate[J ]. Composites Science and Technol- ogy, 2009,69 : 343-348.
  • 5Oosting J. Towards a new durable and environmentally compli- ant adhesive bonding process for aluminum alloys [ D ]. Nether- land: Delft University of Technology, 1995.
  • 6Park S Y, Choi W J, Choi H S, et al. Effects of surface pre-treat- ment and void content on GLARE laminate process characteris- tics [J]. Journal of Materials Processing Technology, 2010,210 (8) : 1008-1016.
  • 7中华人民共和国航空航天工业部.航空工业标准HB/Z197-1991结构胶接铝合金磷酸阳极化工艺规范[s].北京:航空航天工业部,1991.
  • 8Crithlow G W, Brewis D M. Influence of surface macrorough- ness on the durability of epoxide aluminum joints [J]. Interna- tional Journal of Adhesion and Adhesives, 1995, 15 (3) :173-176.
  • 9Zhang J S, Zhao X H, Zuo Y H, et al. The bonding strength and corrosion resistance of aluminum alloy by anodizing treatment in a phosphoric acid modified boric acid sulfuric acid bath[J]. Surface and Coatings Technology, 2008,202 (14) : 3149-3156.
  • 10Botelho E C, Pardini L C, Rezende M C. Hygrothermal effects on damping behavior of metal/glass fiber/epoxy hybrid compos- ites [J]. Materials Science and Engineering A, 2005,399 (1/ 2) : 190-198.

引证文献2

二级引证文献7

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部