双三相分数槽电动机绕组系数分析与计算被引量：2

Analysis and Calculation of Winding Factor for Dual Three-Phase Fractional-Slot Motors

下载PDF

导出

摘要对采用分数槽集中非叠绕组的双三相电动机进行研究,在参照传统三相分数槽电动机极槽配合分析与绕组系数计算的基础上,分析双三相电动机不同的极槽配合情况,计算与之对应的绕组系数,以归纳在极槽配合影响下的绕组系数变化规律,并最终总结出适用于双三相分数槽集中非叠绕组电动机的绕组系数计算公式,可供电机设计以及性能分析作参考。 The dual three-phase motors with concentrated non-overlapping fractional-slot windings were discussed. Referring to the analysis of slot/pole combinations and the calculation of winding factors for conventional three-phase motors with concentrated non-overlapping fractional-slot windings, the slot/pole combinations of dual three-phase motors with con- centrated non-overlapping fractional-slot windings were analyzed. The corresponding winding factors were calculated, and the change rules of the winding factors affected by the slot/pole combinations were concluded based on the above analysis. The computation formula of winding factors for dual three-phase motors with concentrated non-overlapping fractional-slot windings was summarized, which was available to others for motor design and performance analysis.

作者齐歌李景丽周理兵师黎

机构地区郑州大学华中科技大学

出处《微特电机》北大核心 2012年第11期11-14,18,共5页 Small & Special Electrical Machines

基金河南省科技厅科技攻关项目(122102210098) 中国博士后科学基金面上资助项目(2011M501188) 河南省2010年博士后资助项目(2010024)

关键词双三相分数槽集中非叠绕组极槽配合绕组系数 dual three - phase fractional- slot concentrated nonoverlapping winding slot/pole combination winding factor

分类号 TM34 [电气工程—电机]

引文网络
相关文献

参考文献15

1谭建成.三相无刷直流电动机分数槽集中绕组槽极数组合规律研究(连载之一)[J].微电机,2007,40(12):72-77. 被引量：52
2E1-Refaie A M,Zhu Z Q ,Jahns T M,et al. Investigation of winding inductances in fractional slot surface-mounted permanent magnet brushless machines [ J ]. IEEE Industry Applications Society Annu- al Meeting,2008 : 1-8.
3Bianchi N, Bologuani S, Pre M D, et al. Design considerations for fractional- slot winding configurations of synchronous machines [ J]. IEEE Transactions on Industry Applications, 2006, 42 (4) : 997 - 1006.
4Ishak D,Zhu Z Q, Howe D. Rotor eddy current loss in PM ma- chines with fractional slot number per pole[ J]. IEEE Transactions on Magnetics,2005,41 (9) :2462-2469.
5Chen Y S, Zhu Z Q, Howe D. Vibration of permanent magnet brushless machines having a fractional number of slots per pole [J]. IEEE Transactions on Magnetics, 2006, 42 (10) : 3395-3397.
6Salminen P, Niemela M, Pyrhonen J, et al. Performances analysis of fractional slot wound PM- motors for low speed applications [C]//Conf. Rec. IEEE 39th IAS Annu. Meeting. IEEE,2004 (2) :1032-1037.
7Bianchi N, Bolognani S. Design techniques for reducing the cogging torque in surface-mounted PM motors[ J]. IEEE Transactions on Industry Applications ,2002,38 (5) : 1259-1265.
8Bianchi N, Bolognani S, Grezzani G. Fractional-slot IPM servomo- tors: analysis and performance comparisons [ C ]//Proceedings of the International Conference on Electrical Machines. Cracow, Polomd ,2004 : 1-6.
9Bianchi N, Pre M, Grezzani G, et al. Design considerations on frac- tional-slot fault-tolerant synchronous motors [ C ]//IEEE Interna- tional Conference on Electric Machines and Drivers. San Antonio, US,2005:902-909.
10Wrobel R, Mellor P. Design considerations of a direct drive brush- less machine with concentrated windings [ J ]. IEEE Transactionson Energy Conversion, 2008, 23( 1 ) : 1-8.