期刊文献+

CMAS环境下电子束物理气相沉积热障涂层的热循环行为及失效机制 被引量:18

Thermal cycling behavior and associated failure mechanism of EB-PVD thermal barrier coatings with CMAS deposits
原文传递
导出
摘要 航空发动机涡轮叶片工作时表面经常产生CaO-MgO-Al2O3-SiO2(简称CMAS)等沉积物。本文中研究了电子束物理气相沉积(EB-PVD)制备ZrO2热障涂层(TBCs)在CMAS环境下的热循环行为及失效机制。结果表明,在1200℃热冲击条件下,表面涂覆CMAS的热障涂层的热循环寿命低于100次,而未涂覆CMAS的涂层寿命达到500次以上,CMAS的存在加速了热障涂层的剥落失效。在1200℃经过210次循环后,ZrO2陶瓷层与CMAS之间形成了约8μm厚的互反应区,其形成主要与CMAS中Ca2+内扩散有关。CMAS环境下热障涂层陶瓷层产生大量横向裂纹,涂层的失效主要以陶瓷层片状剥落为主。 CaO-MgO-Al2O3-SiO2 (CMAS in short) deposits are often generated on the surface of in-service aircraft engine blades. In this paper, the thermal cycling behavior and associated failure mechanism of EB-PVD zirconia-based thermal barrier coatings (TBCs) with CMAS deposits were investigated. The results show that the thermal cycling life of TBCs with CMAS deposits at 1200℃ is less than 100 cycles, whereas the life of TBCs without CMAS is more than 500 cycles. CMAS deposits accelerate the spallation failure of TBCs. After 210 thermal cycles at 1200℃, about 8 μm interaction layer is formed between CMAS and zirconia ceramic layer, which is mainly due to the inward diffusion of Ca^2+ from the CMAS deposits. A large number of transverse cracks are generated in the ceramic layer of TBCs with CMAS deposits. The failure of TBCs occurs mainly by chipping spallation of the ceramic layer.
出处 《复合材料学报》 EI CAS CSCD 北大核心 2012年第5期76-82,共7页 Acta Materiae Compositae Sinica
基金 国家自然科学基金(50771009 51071013) 国家重点基础研究发展计划(2010CB631200)
关键词 热障涂层 循环热冲击 CMAS 互反应区 失效 TBCs thermal cycling CMAS interaction zone failure
  • 相关文献

参考文献22

  • 1Miller R A. Thermal barrier coatings for aircraft engines: History and directions[J]. Journal of Thermal Spray Technology, I997, 6(1): 35-42.
  • 2Meier S M, Gupta D K. The evolution of thermal barrier coatings in gas turbine engine applications [J].Journal of Emgineering for Gas Turbines and Power, 1994, 116(1) : 250- 257.
  • 3Padture N P, Gell M, Jordan E H. Thermal barrier coatings for gas- turbine engine application[J].cience, 2002, 296 : 280-284.
  • 4StrangmanT, Raybould D, Jameel A, et al. Damage mechanisms, life prediction, and development of EB - PVD thermal barrier coatings for turbine airfoils [J]. Surface and Coatings Technology, 2007, 202(4-7): 658-664.
  • 5Hutchinson J W, Evans A G. On the dclamination of thermal harrier coatings in a thermal gradient [J]. Surface and Coatings Technology, 2002, 149(2/3): 179-184.
  • 6WuRT, Osawa M, Yokokawa T, et al. Degradation mechanisms of an advanced jet engine service - retired TBC component[J]. Journal of Solid Mechanics and Materials Engineering, 2010, 4(2): 119-130.
  • 7Wright P K, Evans A G. Mechanisms governing the performance of thermal barrier coatings[J]. Current Opinion in Solid State and Materials Science, 1999, 4(3): 255-265.
  • 8Kim J, Dunn M G, Baran A J, et al. Deposition of volcanic materials in the hot sections of two gas turbine engines[J].Journal of Engineering for Gas Turbines and Power, 1993, 115(3) : 641-651.
  • 9Stott F H, Wet de D J, Taylor D J. Degradation of thermal- barrier coatings at very high temperatures[J]. MRS Bulletin, 1994, 19(10): 46-49.
  • 10Borom M P, Johnson C A, Peluso L A. Role of environmental deposits and operating surface temperature in spallation of air plasma sprayed thermal barrier coatings [J]. Surface and Coatings Technology, 1996, 86/87(1-3): 116-126.

二级参考文献21

  • 1冀晓鹃,宫声凯,徐惠彬,刘福顺.添加稀土元素对热障涂层YSZ陶瓷层晶格畸变的影响[J].航空学报,2007,28(1):196-200. 被引量:33
  • 2张红菊.多元稀土氧化物掺杂二氧化锆基热障涂层的制备及热循环性能研究[D].北京:北京航空航天大学,2009.
  • 3Miller R A. Thermal barrier coatings for aircraft engines: history and directions [J]. Therm Spray Technol, 1997, 6 (1) : 35-42.
  • 4Tian Y S, Chen C Z, Wang D Y, Ji Q M. Recent developments in zirconia thermal barrier coatings [J]. Surf Rev Lett, 2005, 12(3): 369-378.
  • 5Chwa S O, Ohmori A. Microstructures of ZrO2 -8 wt% Y2O3 coatings prepared by a plasma laser hybrid spraying technique [J]. Surf Coat Technol, 2002, 153(2/3): 304-312.
  • 6Sehulz U, Leyens C, Fritscher K, et al. Some recent trends in research and technology of advanced thermal barrier coatings [J]. Aerosol Sci Technol, 2003, 7(1): 73-80.
  • 7Lehmann H, Pitzer D, Pracht G, Vassen R, Stover D. Effects of doping on thermal conductivity of pyrochlore oxides for advanced thermal barrier coatings [J]. J Am Ceram Soc, 2003, 86: 1338-1344.
  • 8Wu J, Wei X, Padture N P, Klemens P G, Gell M, et al. Low thermal conductivity rare- earth zirconates for potential therma barrier coating applications [J]. J Am Ceram Soc, 2002, 85: 3031-3035.
  • 9Wu J, Padture N P, Klemens P G, Gell M, et al. Thermal conductivity of ceramics in the ZrO2-GdO1.5 system [J]. Mater Res, 2002, 17: 3193-3200.
  • 10Nicholls J R, Lawson K J, Johnstone A, et al. Methods to reduce the thermal conductivity of EB - PVD TBCs [J]. Surf Coat Technol, 2002, 151/152: 383-391.

共引文献17

同被引文献94

引证文献18

二级引证文献164

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部