期刊文献+

EDTA-柠檬酸络合法制备(Ce_(0.8)Y_(0.2-x)Nd_xO_(1.9))_(0.99)(ZnO)_(0.01)电解质材料及其性能研究 被引量:5

Properties of (Ce_(0.8)Y_(0.2-x)Nd_xO_(1.9))_(0.99)(ZnO)_(0.01) Electrolyte Prepared by EDTA-citrate Complexing Method
在线阅读 下载PDF
导出
摘要 采用EDTA-柠檬酸联合络合法制备了(Ce0.8Y0.2-xNdxO1.9)0.99(ZnO)0.01(0≤x≤0.2)系列电解质试样.通过热重、X射线衍射、扫描电镜、热膨胀测试和交流阻抗谱等方法对试样进行分析,着重研究了Y/Nd掺杂配比对CeO2基电解质材料电性能的影响.结果表明:采用EDTA-柠檬酸联合络合法制备的试样均为单一的立方萤石型结构;添加1mol%的ZnO,在1350℃下能得到较为致密的(Ce0.8Y0.2-xNdxO1.9)0.99(ZnO)0.01系列电解质陶瓷片,其中(Ce0.8Y0.05Nd0.15O1.9)0.99(ZnO)0.01电解质试样表现出最高的离子电导率,其在750℃测试时的离子电导率为58.79 mS/cm;所有试样的热膨胀系数在(11.83~12.30)×10 6/K之间. Samples of(Ce0.8Y0.2-xNdxO1.9)0.99(ZnO)0.01(0≤x≤0.2) were synthesized by EDTA-citrate complexing method.The samples were characterized by thermogravimetric,X-ray diffraction,thermal expansion measurement and AC impedance spectroscope,respectively.The effect of Y/Nd dopant ratio on the electrical properties of materials was studied particularly.The results show that all samples prepared by EDTA-citrate complexing method have single cubic fluorite structure.The relatively dense(Ce0.8Y0.2-xNdxO1.9)0.99(ZnO)0.01 series samples can be obtained after sintered at 1350℃ with 1mol% ZnO.Among all the samples,(Ce0.8Y0.05Nd0.15O1.9)0.99(ZnO)0.01 shows the highest ionic conductivity of 58.79 mS/cm measured at 750℃.The thermal expansion coefficients of all samples are in the range of(11.83 12.30)×10-6/K.
出处 《无机材料学报》 SCIE EI CAS CSCD 北大核心 2012年第3期265-270,共6页 Journal of Inorganic Materials
基金 江苏高校优势学科建设工程资助项目(PAPD) 江苏省科技支撑计划(工业)项目(BE2009169)~~
关键词 固体氧化物燃料电池 电解质 EDTA-柠檬酸联合络合法 共掺杂氧化铈 离子电导率 solid oxide fuel cell electrolyte EDTA-citrate complexing method co-doped ceria ionic conductivity
  • 相关文献

参考文献22

  • 1George R A. Status of tubular SOFC field unit demonstrations, Journal of Power Sources, 2000, 86(1/2): 134-139.
  • 2Hibino T, Hashimoto A, Inoue T, et al. A low operating temperature solid oxide fuel cell in hydrocarbon-air mixtures. Science, 2000, 288(5473): 2031-2033.
  • 3Ralph J M, Schoeler A C, Krumpelt M. Materials for lower temperature solid oxide fuel cells. Journal of Materials Science, 2001, 36(5): 1161-1172.
  • 4Gao L, Zhou M, Zheng Y F, et al. Effect of zinc oxide on yttria doped ceria. Journal of Power Sources, 2010, 195(10): 3130-3134.
  • 5Steele B C H. Matericai science and engineering: the enabling technology for the comercialisation of fuel cell systems. Journal of Materials Science, 2001, 36(5): 1053-1068.
  • 6Zhu B. Advantage of intermediate temperature solid oxide fuel cells for tractionary applications. Journal of Power Sources, 2002, 93(1/2): 82-86.
  • 7Steele B C H. Appraisal of Ce1-yGdyO2-y/2 electrolytes for IT- SOFC operation at 500°C, Solid State lonics, 2000, 129(1-4): 95-110.
  • 8Masashi Mori, Eisaku Suda, Bernard Pacaud, et al. Effect of components in electrodes on sintering characteristics of Ce0.9Gd0.1O1.95 electrolyte in solid oxide fuel cells during fabrication. Journal of Power Sources, 2006, 157(2): 688-694.
  • 9Mogensen M, Sammes N M, Tompsett G A. Physical, chemical and electrochemical properties of pure and doped ceria. Solid State lonics, 2000, 129(1-4): 63-94.
  • 10Tadokoro S K, Muccillo E N S. Influence of the precursor purity and the precipitating agent on impedance spectroscopy of CeO2 Y203 ceramics. Journal of Alloys and Compounds, 2004, 374(1/2): 190-193.

同被引文献29

引证文献5

二级引证文献17

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部