摘要
对铸态AM60镁合金在施加不同压力作用下(常压及3、4、5 GPa),450℃固溶处理40 min。使用金相显微镜和X射线衍射仪表征了合金的微观结构,采用显微硬度计和拉伸试验仪研究了合金的力学性能。结果表明,固溶压力的提高促进了合金中沿晶界网状分布的粗大β-Mg17Al12相的破裂并溶入到α-Mg基体。这种现象有利于合金的抗拉强度、伸长率和断面收缩率显著提高,而显微硬度有所下降。
Solution treatment was carried out on as-cast AM60 magnesium alloy at 450 ℃ for 40 min under different pressures-atmospheric pressure,3,4 and 5 GPa respectively.Microstructure of the alloy was characterized by optical microscopy and X-ray diffractiometer.Mechanical properties of the alloy were investigated by micro-hardometer and tensile tester.The results show that increasing the solution pressure promotes the fracture and dissolution into the α-Mg matrix of the coarse β-Mg17Al12phase distributed along the grain boundaries with a network appearance.This phenomena are in favor of an obvious increase in the tensile strength,elongation and reduction of area,but a decrease in the microhardness.
出处
《金属热处理》
CAS
CSCD
北大核心
2012年第2期85-87,共3页
Heat Treatment of Metals
基金
国家自然科学基金项目(No.50975247)
关键词
镁合金
固溶压力
力学性能
magnesium alloy
solution pressure
mechanical properties
