摘要
目前对舰载武器零位系统的检测与规正,都需要远距离基准目标。本文提出在武器和中心控制系统上分别标示点目标,利用两台TCA2003高性能全站仪对点目标进行同步分别观测,利用观测数据求解观测目标与中心线之间固定的几何关系,实现根据观测数据推导武器和中心控制系统二者的中心线的方位,进而计算两条中心线的夹角关系,最终获得零位误差值,避免了选择远距离的基准目标。实际观测并仿真分析可知,本文提出的计算方法,精度可达到,完全满足零位校检的要求。
This paper present a computational method in order to obtain the value of zero position error between shipboard weapon and centre system without collimating a datum target,which is based on the conclusion of the data getting by observing the targets marked on the shipboard weapon and centre system.The data of the two targets on the shipboard weapon and the centre control system is surveyed at the same time by two ETS in two different survey stations.The method proposes a premise of deducing the true value between the centre lines in the shipboard weapon and control system.And the conclusion of the computational method presented in this paper is proved precise enough according to the simulation in the real data.
出处
《长春理工大学学报（自然科学版）》
2010年第4期77-80,共4页
Journal of Changchun University of Science and Technology(Natural Science Edition)
关键词
零位校检
TCA2003全站仪
基准目标
同步测量
仿真分析
zero position adjustment
ETS（Electronic Total Station） TCA2003
datum target
synchro measure
simulation analysis
