摘要
提出一种建立具有柔性关节的多柔杆机器人动力学方程的方法．首先给出了柔性关节及柔性臂杆的简化模型，然后利用Ｋａｎｅ方法和假设模态法推导出完整的动力学方程并给出了递推公式．在此基础上利用一个算例研究了臂杆柔性与关节柔性对机器人动力学响应的影响．结果表明：所建立的动力学模型更接近于实际的柔性机器人系统；臂杆柔性与关节柔性都起着非常重要的作用。
A method was presented for establishing the dynamic equation of the flexible multi link manipulator with flexible joints. Firstly, the simplified models of a flexible joint and a flexible link are described respectively, then based on Kane's method and assumptive modes method, the complete dynamic equation of the flexible manipulator is derived and its recursive formulation is given. On this basis, the influence caused by the link flexibility and joint flexibility on the dynamic response is studied using an example. The results show the dynamic model described in this paper is more similar to the actual flexible manipulator system, and both link flexibility and joint flexibility are important in the flexible manipulator system, therefore their influence should be taken fully into account in the dynamic modeling and control of flexible manipulators.
出处
《北京航空航天大学学报》
EI
CAS
CSCD
北大核心
1999年第4期486-490,共5页
Journal of Beijing University of Aeronautics and Astronautics
基金
国家自然科学基金
博士点基金
关键词
动力学方程
模态分析
柔性机器人
建模
model building
kinetics equations
modal analysis
flexible manipulator
