期刊文献+

热处理对Mg-Zn-Y-Zr合金组织及性能的影响 被引量:6

Effect of heat treatment on microstructure and properties of Mg-Zn-Y-Zr alloy
原文传递
导出
摘要 研究了热处理对Mg-0.8Zn-0.15Y-0.6Zr合金微观组织、力学性能及阻尼性能的影响。结果表明:合金铸态及热处理态的微观组织均由α-Mg和(Mg3YZn6)相组成,(Mg3YZn6)相在热处理过程中表现出良好的热稳定性;热处理温度为400℃时,组织中有富Zr的α-Mg新相析出。与铸态相比,合金热处理后的抗拉强度最大提高了15.2%,伸长率最大提高了10.4%。随着热处理温度的升高,合金应变振幅无关阻尼性能逐渐降低。 Effect of heat treatment on microstructure,mechanical and damping properties of Mg-0.8Zn-0.15Y-0.6Zr alloy was investigated.Experimental results show that the microstructure of as-cast and heat-treated alloy all consists of α-Mg and I-phase(Mg3YZn6),and I-phase is thermally stable during the process of heat treatment.A new Zr-rich α-Mg phase is formed when the heat treatment temperature is 400 ℃.Compared with the as-cast alloy,the tensile strength and the elongation of heat-treated alloy present a maximum increase of 15.2% and 10.4%,respectively.The damping capacity independent of strain amplitude gradually decreases with the increase of the heat treatment temperature.
出处 《材料热处理学报》 EI CAS CSCD 北大核心 2010年第7期94-98,共5页 Transactions of Materials and Heat Treatment
基金 国家自然科学基金(50671083) 陕西省自然科学基金(2007E101)
关键词 MG-ZN-Y-ZR合金 热处理 微观组织 力学性能 阻尼性能 Mg-Zn-Y-Zr alloy heat treatment microstructure mechanical property damping property
  • 相关文献

参考文献12

  • 1曾荣昌,柯伟,徐永波,韩恩厚,朱自勇.Mg合金的最新发展及应用前景[J].金属学报,2001,37(7):673-685. 被引量:450
  • 2林琳,王改芳,陈先毅,王锦程,杨根仓.稀土元素Y对Mg-0.6%Zr合金力学性能与阻尼行为的影响[J].铸造技术,2008,29(6):769-772. 被引量:4
  • 3郭华明,刘子利,刘新波.Y含量对Mg-Zn-Y合金组织和性能的影响[J].特种铸造及有色合金,2006,26(10):664-666. 被引量:9
  • 4Ju Youn Lee, Hyun Kyu Lim, Do Hyung Kim, et al. Effect of volume fraction of quasicrystal on the mechanical properties of quasicrystal-reinforced Mg-Zn-Y alloys[ J]. Materials Science and Engineering A, 2007, 449 -451:987 -990.
  • 5樊建锋.镁合金的高温氧化及阻燃理论研究[D].西安:西北工业大学,2005.
  • 6万迪庆.镁基高阻尼合金组织、性能及内耗研究[D].西安:西北工业大学,2009:64-72.
  • 7Xu D K, Hart En-hou, Liu L, et al. Influence of higher Zn/Y ratio on the microstructure and mechanical properties of Mg-Zn-Y-Zr alloys[ J]. Metallurgical and Materials Transactions A, 2009, 40 : 1727 - 1740.
  • 8Clementi E, Raimondi D L, Reinhardt W P. Atomic screening constants from SCF functions[J]. J Chem Phys, 1963, 38:2686.
  • 9张忠明,王锦程,刘宏昭,杨根仓.过饱和ZAC27合金的阻尼性能与组织演变[J].中国有色金属学报,2000,10(3):306-312. 被引量:17
  • 10Granato A, Ltlcker K. Theory of mechanical damping due to dislocations[ J]. Journal of Applied Physics, 1956, 27 (6) : 583 -593.

二级参考文献22

  • 1刘刚强,陈乐平,艾云龙.稀土Nd对ZM5合金组织与性能影响的研究[J].特种铸造及有色合金,2005,25(8):496-498. 被引量:24
  • 2朱贤方,水嘉鹏.计算自由衰减内耗准确公式[J].理化检验(物理分册),1995,31(4):45-46. 被引量:1
  • 3Luo Z P,Zhang S Q.High-resolution Electron Microscopy on the X-Mg12ZnY Phase in a High Strength Mg-Zn-Zr-Y Magnesium Alloy.Journal of Materials Science Letters,2000,19:813~815
  • 4Padezhnova E M,Mel'nik E V,Miliyevskiy R A,et al.Investigation of the Mg-Zn-Y system.Russian Metallurgy,1982.4:185~190
  • 5Zhang Y,Zeng X q,Liu L f,et al.Effects of Yttrium on Microstructure and Mechanical Properties of Hot-extruded Mg-Zn-Y-Zr Alloys.Materials Science and Engineering,2004,A373:320~327
  • 6Singh A,Tsai A P.A New Orientation Relationship OR4 of Icosahedral Phase with Magnesium Matrix in Mg-Zn-Y Alloys.Scripta Materialia,2005,53:1 083~1 087
  • 7Singh A,Watanabe M,Kato A,et al.Crystallographic Orientations and Interfaces of Icosahedral Quasicrystalline Phase Growing on Cubic W Phase in Mg-Zn-Y Alloys.Materials Science and Engineering,2005,A397:22~34
  • 8Lee J Y,Kim D H,Lim H K,et al.Effects of Zn/Y Ratio on Microstructure and Mechanical Properties of Mg-Zn-Y alloys.Materials Letters 2005,59:3 801~3 805
  • 9Zhenyan Zhang, Xiaoqin Zeng, Wenjiang Ding. The influence of heat treatment on damping response of AZ91D magnesium alloy [J]. Materials Science and Engineering A,2005, 392:150-155.
  • 10X S Hu, K Wu, M Y Zheng, et al. Low frequency damping capacities and mechanical properties of Mg-Si alloys [J]. Materials Science and Engineering A, 2007, 452-453: 374-379.

共引文献474

同被引文献48

引证文献6

二级引证文献2

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部