摘要
为了处理印染废水，介绍一种以铁屑、烟道灰或瓦斯灰为处理剂的新方法，探讨了处理机理，给出了适宜的处理条件和工艺流程。实验结果表明，当处理剂用量比在４：６左右，铁屑过滤和混凝吸附的ｐＨ值分别控制在４～５和８～９时，处理２０ｍｉｎ，经处理后的印染废水，ＣＯＤ去除率和脱色率均可达９０％以上，出水ＣＯＤ全部低于１００ｍｇ／Ｌ，水质清澈透明，各项水质指标均符合国家排放标准。该法适用于中小型纺织印染厂的废水治理。
A new method for treating dyeing waste water with iron filings, flue gas or gas ashes as treating agent is introduced. The treatment mechanism is discussed and the proper treating conditions and technological procedures are suggested. The experimental results show that when the ratio of treating agent is 4:6, PH values of iron filings filtering and coagulation absorption are controlled at 4～5 and 8～9 respectively, treating time is 20～30min, the rate of dislodgement and decolouring after treating can reach over 90%; all the values of COD are less than 100 mg/L;the waste water becomes clear and transparent; and all the quality indexes of water conform with the national dischange standards.
出处
《中国环境科学》
EI
CAS
CSSCI
CSCD
北大核心
1995年第5期378-382,共5页
China Environmental Science
关键词
电化腐蚀
还原降解
混凝吸附
印染废水
废水处理
galvanic corrosion
reduction degradation
coagulation absorption, dyeing waste water, COD dislodgement rate.
