期刊文献+

直扩码分多址个人通信系统在衰落信道中的多用户信号检测 被引量:1

Multiuser Signal Detection for Multipath Fading Channels in DS-CDMA PCN System
在线阅读 下载PDF
导出
摘要 本文在DS-CDMA PCN系统抗干扰性能的分析中,首次提出了用户归一化扩频信号等效左半部分和等效右半部分的分析模型,并在此基础上有效地结合传统扩频通信RAKE接收机的抗多径性能和多用户信号检测器的抗多址干扰特性,得到了一种能同时消除同频干扰和对抗多径衰落的多用户信号检测新方法。 By means of interference analysis in DS-CDMA PCN system, a analytical model concerned with equvalent left section and equvalent right section of the user's normalization spread spectrum signal is proposed firstly in this paper. According to this concept, combined with traditional spread spectrum RAKE receiver for fading channels and some newly multi-user signal detectors for erasing cochannel interference, a new algorithm is derived which can simultaneously eliminate the cochannel interferece and resist the multipath fading.
机构地区 清华大学
出处 《通信学报》 EI CSCD 北大核心 1995年第1期33-39,共7页 Journal on Communications
关键词 码分多址 信号检测 个人通信 衰落信道 code division multiple access, multiuser signal detection, cochannel interference, multipath fading
  • 相关文献

参考文献1

  • 1Tao C,ICCT’92

同被引文献7

  • 1崔莉,鞠海玲,苗勇,李天璞,刘巍,赵泽.无线传感器网络研究进展[J].计算机研究与发展,2005,42(1):163-174. 被引量:732
  • 2田社平,赵阳,韦红雨,王志武.基于神经网络模型的传感器非线性校正(英文)[J].光学精密工程,2006,14(5):896-902. 被引量:17
  • 3IEEE Computer Society. Wireless medium access control (MAC) and physical layer (PHY) specifications for low rate wireless personal area networks (LR-WPANs)[P]. IEEE Std 802. 15.4TM-2003.
  • 4LIU B H,CHO CH T, JUSTIN I., et al.. Using frequency division to reduce MAI in DS-CDMA wireless sensor networks[J]. IEEE Communications Society, 2005,2:657- 663.
  • 5HOLMESJ K, CHEN CH C. Acquisition time performance of PN spread-spectrum systems[J]. IEEETransactions On Communications, 1977,25(8) : 778- 784.
  • 6LINATTI J H J. On the threshold setting principles in code acquisition of DS-SS signals[J].IEEE Journal on Selected Areas in Communications, 2000,18(1) : 62-72.
  • 7钟先信,李晓毅,巫正中,余文革.无线网络化微传感器及其嵌入式系统(英文)[J].光学精密工程,2003,11(3):227-233. 被引量:4

引证文献1

二级引证文献5

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部