摘要
在武器的设计过程中,机心强度的校核非常重要。设计强度恰当、结构合理的机心是武器设计中必须慎重考虑的问题。结合传统校核机心的方法,利用ANSYS有限元分析软件分别进行静态和瞬态分析,而且结合接触分析指出计算结果之间的差别和以后设计、校核时的注意事项。
In the weapon＇s design process, it is very important to verify the bolt＇s strength. To design a suitable strength and reasonable structure bolt is an important issue in the design process. This paper refers to conventional verification method and uses ANSYS analysis software to research the bolt in static and transient situation respectively, moreover, it connects the contact analysis and points out the difference and some matters needed attention in latter design and verification.
出处
《机械工程与自动化》
2005年第4期25-27,共3页
Mechanical Engineering & Automation
关键词
机心
强度
静态分析
瞬态分析
bolt
strength
static analysis
transient analysis
