Two methods of irrigation,drip,and sprinkler were studied to determine the response of the Javits green roof to irrigation.The control study was dry unirrigated plots.Drip irrigation consisted of irrigation tubes runn...Two methods of irrigation,drip,and sprinkler were studied to determine the response of the Javits green roof to irrigation.The control study was dry unirrigated plots.Drip irrigation consisted of irrigation tubes running through the green roof that would water the soil throughout and sprinkler irrigation used a sprinkler system to irrigate the green roof from above.In all cases,the irrigated roofs had increased the soil moisture,reduced temperatures of both the upper and lower surfaces,reduced growing medium temperatures and reduced air temperatures above the green roof relative to the unirrigated roof.The buffered temperature fluctuations were also studied via air conditioner energy consumption.There was a 28%reduction in air conditioner energy consumption and a 33%reduction in overall energy consumption between dry and irrigated plots.Values of thermal resistance or S were determined for accuracy and for this study,there was little change which is ideal.A series of infra-red and thermal probe measurements were used to determine temperatures in the air and sedum.It was determined that the sprinkler irrigation did a better job than the drip irrigation in keeping cooler temperatures within the green roof.A Mann-Whitney U test was performed to verify the variation in moisture temperatures buffering energy consumption.By getting a p-value<0.05,it indicates that the model is accurate for prediction and medium temperatures were statistically different.展开更多
Efficient thermal buffering for high heat flux electronics is a critical challenge.To tackle this issue,the study introduces a finned phase change thermal buffer(PCTB)scheme.By developing a modified apparent heat capa...Efficient thermal buffering for high heat flux electronics is a critical challenge.To tackle this issue,the study introduces a finned phase change thermal buffer(PCTB)scheme.By developing a modified apparent heat capacity method,this work investigates internal close contact melting(CCM)and constrained melting(CM),emphasizing the impact of PCTB inclinations on electronics'thermal control performance.The findings reveal the significant influence of natural convection on CM,compared to CCM.In scenarios with natural convection,the entire melting duration of the CM and CCM in the horizontal PCTB decreases by 21.7%and 2%,respectively.The early melting phase is predominantly governed by heat conduction in both CM and CCM.As the molten PCM increases,natural convection emerges in CM,while mixed convection occurs in CCM.The effect of inclination angle on CM and CCM varies,with the most rapid melting rates observed at 0°for CM and 60°for CCM.The thermal control efficacy of PCTBs in CCM mode surpasses that in CM mode and is less influenced by the inclination angle.Furthermore,electronics exhibit the longest safe operating time(218-227 s)and highest latent heat utilization efficiency(98.6%-100%)with a horizontal PCTB,confirming the superiority of this configuration.展开更多
The thermal property is one of the key properties for the design of the high-level radioactive waste (HLW) repository. In this study, the thermal properties transient automatic tester (HPP-F) is uesd to study the ther...The thermal property is one of the key properties for the design of the high-level radioactive waste (HLW) repository. In this study, the thermal properties transient automatic tester (HPP-F) is uesd to study the thermal conductivity of multiphase composite buffer/backfill material including the type B-Z and B-Z-P (Here B、Z、P represents bentonite、zeolite and pyrite respectively,the same as in the following.) in different dry density and moisture conditions. The results show that for the same moisture content (dry density), thermal conductivity of specimens increases as the dry density (moisture content) increases. As a result, the type B-Z-P which is highly compacted of 1.8 g/cm3 in dry density and 17.65% in moisture content performs well, it meets the requirements of the IAEA and is easy to be compacted ,so it can be recommend as a alternative material of high level radioactive waste disposal repository buffer/backfilling materials.展开更多
高放废物地质处置库缓冲/回填材料的重要作用之一是传导和散失高放废物衰变热,在膨润土中添加石英砂、石墨、花岗岩岩屑等导热性能较好的添加剂是提高缓冲/回填材料导热性能的主要方法。选用北山花岗岩岩屑为添加剂,与高庙子钠基膨润土G...高放废物地质处置库缓冲/回填材料的重要作用之一是传导和散失高放废物衰变热,在膨润土中添加石英砂、石墨、花岗岩岩屑等导热性能较好的添加剂是提高缓冲/回填材料导热性能的主要方法。选用北山花岗岩岩屑为添加剂,与高庙子钠基膨润土GMZ01组成混合材料,制备不同含水率、不同密度的试样。使用Hot Disk TPS2500s热常数分析仪测定样品的导热系数,分析其与花岗岩岩屑含量、干密度、饱和度等参数的关系,并运用多种混合物热传导模型分析预测导热系数。研究结果表明,花岗岩岩屑能够有效提高缓冲/回填材料的导热性能,混合材料的导热系数分别与其饱和度、气体体积存在线性关系;Maxwell方程能够较好预测北山花岗岩岩屑-膨润土混合材料的导热系数。展开更多
文摘Two methods of irrigation,drip,and sprinkler were studied to determine the response of the Javits green roof to irrigation.The control study was dry unirrigated plots.Drip irrigation consisted of irrigation tubes running through the green roof that would water the soil throughout and sprinkler irrigation used a sprinkler system to irrigate the green roof from above.In all cases,the irrigated roofs had increased the soil moisture,reduced temperatures of both the upper and lower surfaces,reduced growing medium temperatures and reduced air temperatures above the green roof relative to the unirrigated roof.The buffered temperature fluctuations were also studied via air conditioner energy consumption.There was a 28%reduction in air conditioner energy consumption and a 33%reduction in overall energy consumption between dry and irrigated plots.Values of thermal resistance or S were determined for accuracy and for this study,there was little change which is ideal.A series of infra-red and thermal probe measurements were used to determine temperatures in the air and sedum.It was determined that the sprinkler irrigation did a better job than the drip irrigation in keeping cooler temperatures within the green roof.A Mann-Whitney U test was performed to verify the variation in moisture temperatures buffering energy consumption.By getting a p-value<0.05,it indicates that the model is accurate for prediction and medium temperatures were statistically different.
基金supported by the National Natural Science Foundation of China(Grant No.52306077)the China Postdoctoral Science Foundation(Grant No.2023M730556)。
文摘Efficient thermal buffering for high heat flux electronics is a critical challenge.To tackle this issue,the study introduces a finned phase change thermal buffer(PCTB)scheme.By developing a modified apparent heat capacity method,this work investigates internal close contact melting(CCM)and constrained melting(CM),emphasizing the impact of PCTB inclinations on electronics'thermal control performance.The findings reveal the significant influence of natural convection on CM,compared to CCM.In scenarios with natural convection,the entire melting duration of the CM and CCM in the horizontal PCTB decreases by 21.7%and 2%,respectively.The early melting phase is predominantly governed by heat conduction in both CM and CCM.As the molten PCM increases,natural convection emerges in CM,while mixed convection occurs in CCM.The effect of inclination angle on CM and CCM varies,with the most rapid melting rates observed at 0°for CM and 60°for CCM.The thermal control efficacy of PCTBs in CCM mode surpasses that in CM mode and is less influenced by the inclination angle.Furthermore,electronics exhibit the longest safe operating time(218-227 s)and highest latent heat utilization efficiency(98.6%-100%)with a horizontal PCTB,confirming the superiority of this configuration.
文摘The thermal property is one of the key properties for the design of the high-level radioactive waste (HLW) repository. In this study, the thermal properties transient automatic tester (HPP-F) is uesd to study the thermal conductivity of multiphase composite buffer/backfill material including the type B-Z and B-Z-P (Here B、Z、P represents bentonite、zeolite and pyrite respectively,the same as in the following.) in different dry density and moisture conditions. The results show that for the same moisture content (dry density), thermal conductivity of specimens increases as the dry density (moisture content) increases. As a result, the type B-Z-P which is highly compacted of 1.8 g/cm3 in dry density and 17.65% in moisture content performs well, it meets the requirements of the IAEA and is easy to be compacted ,so it can be recommend as a alternative material of high level radioactive waste disposal repository buffer/backfilling materials.
文摘高放废物地质处置库缓冲/回填材料的重要作用之一是传导和散失高放废物衰变热,在膨润土中添加石英砂、石墨、花岗岩岩屑等导热性能较好的添加剂是提高缓冲/回填材料导热性能的主要方法。选用北山花岗岩岩屑为添加剂,与高庙子钠基膨润土GMZ01组成混合材料,制备不同含水率、不同密度的试样。使用Hot Disk TPS2500s热常数分析仪测定样品的导热系数,分析其与花岗岩岩屑含量、干密度、饱和度等参数的关系,并运用多种混合物热传导模型分析预测导热系数。研究结果表明,花岗岩岩屑能够有效提高缓冲/回填材料的导热性能,混合材料的导热系数分别与其饱和度、气体体积存在线性关系;Maxwell方程能够较好预测北山花岗岩岩屑-膨润土混合材料的导热系数。
