The traditional communication system is effectively designed for the worst-case channel state and it can not use the spectral efficiently over the time-varying multipath channel. In order to improve the spectral effic...The traditional communication system is effectively designed for the worst-case channel state and it can not use the spectral efficiently over the time-varying multipath channel. In order to improve the spectral efficiency and ensure robust and spectrally-efficient transmission over the time-varying multipath channel,a joint rate control and adaptive modulation and coding ( AMC) algorithm for adaptive transmission systems is proposed in this paper. Firstly,the proposed algorithm can formulate a modulation and coding scheme ( MCS) switching table according to the offline simulation results and the target bit error rate ( BER) . Then,the optimal MCS is selected in MCS switching table according to the channel state information ( CSI) and then passes to the transmitter and receiver to implement. So the adaptive system which always uses the optimal MCS to transmit signals uses the spectral efficiently. The simulation results validate the proposed algorithm and show that under the premise of meeting the target BER,the adaptive system performing the proposed algorithm has a higher average spectral efficiency ( ASE) than that of the non-adaptive system.展开更多
This paper proposes a high performance three-level inverter Neutral Point Clamped (NPC) structure for photovoltaic system. The proposed configuration which can boost the low voltage of photovoltaic (PV) array, can als...This paper proposes a high performance three-level inverter Neutral Point Clamped (NPC) structure for photovoltaic system. The proposed configuration which can boost the low voltage of photovoltaic (PV) array, can also convert the photovoltaic DC power into high quality AC power. Attention has been paid to the problem of neutral point potential variation. In this way, a Direct Torque Control (DTC) technique has been applied and the estimated value of the Neutral Point Potential (NPP) is used, which is calculated by motor currents. This control strategy uses the redundancy presented by the inverter for selecting appropriate switching state through a switching table to achieve the control of NPP. This study shows the effect of the stability problem of the DC voltages and good static and dynamic performances were obtained in simulation of the proposed cascade “photovoltaic cell-three-level NPC VSI-induction motor”.展开更多
This paper presents a mathematical model of three-level voltage PWM rectifier,and derives a power control model from the theory of instantaneous power.In the vector-space,the influences on instantaneous power exercise...This paper presents a mathematical model of three-level voltage PWM rectifier,and derives a power control model from the theory of instantaneous power.In the vector-space,the influences on instantaneous power exercised by all the switching vectors are studied and illustrated separately,then a direct power control(DPC) scheme for three-level PWM rectifier which uses multistage band hysteresis comparator is proposed,and a novel switching table is designed.Meanwhile,the neutralpoint voltage unbalance is inhibited by selecting the redundancy switching states of small voltage vectors.Simulation and experimental results show that the proposed strategy can not only stabilize the DC bus voltage but also realize the unity power factor operation and the balance of neutral-point voltage.Moreover,the proposed method can improve the performance of the three-level rectifier.展开更多
This article presents the direct torque control (DTC) strategy for the doubly fed induction motor (DFIM) connected to two three-level voltage source inverters (3LVSIs) with neutral point clamped (NPC) structure. This ...This article presents the direct torque control (DTC) strategy for the doubly fed induction motor (DFIM) connected to two three-level voltage source inverters (3LVSIs) with neutral point clamped (NPC) structure. This control method allows to reduce the torque and flux ripples as well as to optimize the total harmonic distortion (THD) of motor currents. The use of 3LVSI increases the number of generated voltage, which allows improving the quality of its waveform and thus improves the DTC strategy. The system modeling and control are implemented in Matlab/Simulink environment. The analysis of simulation results shows the better performances of this control, especially in terms of torque and flux behavior, compared to conventional DTC.展开更多
基金Sponsored by the National Natural Science Foundation and Civil Aviation Administration of China(Grant No.61101122 and 61071104)the Science and Technology on Information Transmission and Dissemination in Communication Networks Laboratory(Grant No.ITD-U12004/K1260010)
文摘The traditional communication system is effectively designed for the worst-case channel state and it can not use the spectral efficiently over the time-varying multipath channel. In order to improve the spectral efficiency and ensure robust and spectrally-efficient transmission over the time-varying multipath channel,a joint rate control and adaptive modulation and coding ( AMC) algorithm for adaptive transmission systems is proposed in this paper. Firstly,the proposed algorithm can formulate a modulation and coding scheme ( MCS) switching table according to the offline simulation results and the target bit error rate ( BER) . Then,the optimal MCS is selected in MCS switching table according to the channel state information ( CSI) and then passes to the transmitter and receiver to implement. So the adaptive system which always uses the optimal MCS to transmit signals uses the spectral efficiently. The simulation results validate the proposed algorithm and show that under the premise of meeting the target BER,the adaptive system performing the proposed algorithm has a higher average spectral efficiency ( ASE) than that of the non-adaptive system.
文摘This paper proposes a high performance three-level inverter Neutral Point Clamped (NPC) structure for photovoltaic system. The proposed configuration which can boost the low voltage of photovoltaic (PV) array, can also convert the photovoltaic DC power into high quality AC power. Attention has been paid to the problem of neutral point potential variation. In this way, a Direct Torque Control (DTC) technique has been applied and the estimated value of the Neutral Point Potential (NPP) is used, which is calculated by motor currents. This control strategy uses the redundancy presented by the inverter for selecting appropriate switching state through a switching table to achieve the control of NPP. This study shows the effect of the stability problem of the DC voltages and good static and dynamic performances were obtained in simulation of the proposed cascade “photovoltaic cell-three-level NPC VSI-induction motor”.
基金supported by the Key Program of National Natural Science Foundation of China (Grant No. 51037004)the National Natural Science Foundation of China (Grant No. 51077097)the Key Technologies Research and Development Program of Tianjin (Grant No.11ZCKFGX03300)
文摘This paper presents a mathematical model of three-level voltage PWM rectifier,and derives a power control model from the theory of instantaneous power.In the vector-space,the influences on instantaneous power exercised by all the switching vectors are studied and illustrated separately,then a direct power control(DPC) scheme for three-level PWM rectifier which uses multistage band hysteresis comparator is proposed,and a novel switching table is designed.Meanwhile,the neutralpoint voltage unbalance is inhibited by selecting the redundancy switching states of small voltage vectors.Simulation and experimental results show that the proposed strategy can not only stabilize the DC bus voltage but also realize the unity power factor operation and the balance of neutral-point voltage.Moreover,the proposed method can improve the performance of the three-level rectifier.
文摘This article presents the direct torque control (DTC) strategy for the doubly fed induction motor (DFIM) connected to two three-level voltage source inverters (3LVSIs) with neutral point clamped (NPC) structure. This control method allows to reduce the torque and flux ripples as well as to optimize the total harmonic distortion (THD) of motor currents. The use of 3LVSI increases the number of generated voltage, which allows improving the quality of its waveform and thus improves the DTC strategy. The system modeling and control are implemented in Matlab/Simulink environment. The analysis of simulation results shows the better performances of this control, especially in terms of torque and flux behavior, compared to conventional DTC.
