This paper focuses on a new approach to design(possibly fractional) set-point filters for fractional control systems.After designing a smooth and monotonic desired output signal,the necessary command signal is obtaine...This paper focuses on a new approach to design(possibly fractional) set-point filters for fractional control systems.After designing a smooth and monotonic desired output signal,the necessary command signal is obtained via fractional input-output inversion.Then,a set-point filter is determined based on the synthesized command signal.The filter is computed by minimizing the 2-norm of the difference between the command signal and the filter step response.The proposed methodology allows the designer to synthesize both integer and fractional setpoint filters.The pros and cons of both solutions are discussed in details.This approach is suitable for the design of two degreeof-freedom controllers capable to make the set-point tracking performance almost independent from the feedback part of the controller.Simulation results show the effectiveness of the proposed methodology.展开更多
A PI control strategy based on fuzzy set-point weighting following was proposed for the active damping control of a hydraulic crane boom system （HCBS）. Two valve-controlled PI controllers, which include a proportion...A PI control strategy based on fuzzy set-point weighting following was proposed for the active damping control of a hydraulic crane boom system （HCBS）. Two valve-controlled PI controllers, which include a proportional feedforward controller based on fuzzy set-point weighting following and a limited semi-integrator（LSI）, are designed respectively. LSI is used to limit output signal and to prevent wind up at the low frequency of the spectrum. By using a range camera and an electronic feedback control, the tip damping on the HCBS can be adjusted artificially. A collaborative control simulation technique of HOPSAN and MATLAB/SIMULINK is applied to the controller design. Simulation results show that the proposed PI control system has less overshoot as well as faster response. The tip damping on the HCBS during operation is improved.展开更多
A program control was applied in the fuel gas shuttle kiln,and its principle and disadvantge were analyzed.An advanced set point control method,in which the change rate of temperature is the controlled variable,is als...A program control was applied in the fuel gas shuttle kiln,and its principle and disadvantge were analyzed.An advanced set point control method,in which the change rate of temperature is the controlled variable,is also described,and the new control system makes the control precision of temperature improved.展开更多
This paper introduces an electrical drives control architecture combining a fractional-order controller and a setpoint pre-filter. The former is based on a fractional-order proportional-integral(PI) unit, with a non-i...This paper introduces an electrical drives control architecture combining a fractional-order controller and a setpoint pre-filter. The former is based on a fractional-order proportional-integral(PI) unit, with a non-integer order integral action, while the latter can be of integer or non-integer type. To satisfy robustness and dynamic performance specifications, the feedback controller is designed by a loop-shaping technique in the frequency domain. In particular, optimality of the feedback system is pursued to achieve input-output tracking. The setpoint pre-filter is designed by a dynamic inversion technique minimizing the difference between the ideal synthesized command signal(i.e., a smooth monotonic response) and the prefilter step response. Experimental tests validate the methodology and compare the performance of the proposed architecture with well-established control schemes that employ the classical PIbased symmetrical optimum method with a smoothing pre-filter.展开更多
Objective： To evaluate the efficiency of an implanted chip system for the control of heart rate （HR）. Methods： The HR was recorded in six conscious Sprague-Dawley （SD） rats. An implanted chip system was designed...Objective： To evaluate the efficiency of an implanted chip system for the control of heart rate （HR）. Methods： The HR was recorded in six conscious Sprague-Dawley （SD） rats. An implanted chip system was designed to regulate the HR by stimulating the right cervical vagus nerve according to the feedback of real time HR. Each rat was subjected to 30-min regulation and 30-min recovery. The change of HR during the regulation period was compared with the control. The ECG was recorded during the experiment for 24 h. Results： The ECG signals were successfully recorded during the experiment. The HR was significantly decreased during the period of regulation compared with control （-79.3 ± 34.5, P 〈 0.01, n = 6） and then recovered to normal after regulation. Conclusion： The described implanted chip system can regulate the HR to a designated set point.展开更多
基金supported by the Australian Research Council(DP160104994)
文摘This paper focuses on a new approach to design(possibly fractional) set-point filters for fractional control systems.After designing a smooth and monotonic desired output signal,the necessary command signal is obtained via fractional input-output inversion.Then,a set-point filter is determined based on the synthesized command signal.The filter is computed by minimizing the 2-norm of the difference between the command signal and the filter step response.The proposed methodology allows the designer to synthesize both integer and fractional setpoint filters.The pros and cons of both solutions are discussed in details.This approach is suitable for the design of two degreeof-freedom controllers capable to make the set-point tracking performance almost independent from the feedback part of the controller.Simulation results show the effectiveness of the proposed methodology.
基金This work was supported by the Natural Science Foundation of Hunan Province(No.04JJ6033) and Scientific Research Fund of Hunan ProvincialEducation Department(No. 03C066).
文摘A PI control strategy based on fuzzy set-point weighting following was proposed for the active damping control of a hydraulic crane boom system （HCBS）. Two valve-controlled PI controllers, which include a proportional feedforward controller based on fuzzy set-point weighting following and a limited semi-integrator（LSI）, are designed respectively. LSI is used to limit output signal and to prevent wind up at the low frequency of the spectrum. By using a range camera and an electronic feedback control, the tip damping on the HCBS can be adjusted artificially. A collaborative control simulation technique of HOPSAN and MATLAB/SIMULINK is applied to the controller design. Simulation results show that the proposed PI control system has less overshoot as well as faster response. The tip damping on the HCBS during operation is improved.
文摘A program control was applied in the fuel gas shuttle kiln,and its principle and disadvantge were analyzed.An advanced set point control method,in which the change rate of temperature is the controlled variable,is also described,and the new control system makes the control precision of temperature improved.
基金partially supported by the Australian Research Council(DP160104994)
文摘This paper introduces an electrical drives control architecture combining a fractional-order controller and a setpoint pre-filter. The former is based on a fractional-order proportional-integral(PI) unit, with a non-integer order integral action, while the latter can be of integer or non-integer type. To satisfy robustness and dynamic performance specifications, the feedback controller is designed by a loop-shaping technique in the frequency domain. In particular, optimality of the feedback system is pursued to achieve input-output tracking. The setpoint pre-filter is designed by a dynamic inversion technique minimizing the difference between the ideal synthesized command signal(i.e., a smooth monotonic response) and the prefilter step response. Experimental tests validate the methodology and compare the performance of the proposed architecture with well-established control schemes that employ the classical PIbased symmetrical optimum method with a smoothing pre-filter.
基金supported by grant from National Nature Science Found (30670767)
文摘Objective： To evaluate the efficiency of an implanted chip system for the control of heart rate （HR）. Methods： The HR was recorded in six conscious Sprague-Dawley （SD） rats. An implanted chip system was designed to regulate the HR by stimulating the right cervical vagus nerve according to the feedback of real time HR. Each rat was subjected to 30-min regulation and 30-min recovery. The change of HR during the regulation period was compared with the control. The ECG was recorded during the experiment for 24 h. Results： The ECG signals were successfully recorded during the experiment. The HR was significantly decreased during the period of regulation compared with control （-79.3 ± 34.5, P 〈 0.01, n = 6） and then recovered to normal after regulation. Conclusion： The described implanted chip system can regulate the HR to a designated set point.
