The synthetic making test has been widely used in evaluating the break ability of high-voltage circuit breaker. However, the test research and application are still inadequate, especially in the condition of rated vol...The synthetic making test has been widely used in evaluating the break ability of high-voltage circuit breaker. However, the test research and application are still inadequate, especially in the condition of rated voltage. According to the realistic conditions of test stations in China, a control device based on pre-arcing current detection and phase control is proposed in this paper. A sample of the control device made up of DSP TMS320LF2407A is fabricated, in which the CPLD MAX7064 is used to transmit signals for EMC design. It can be applied in full voltage synthetic making test at a level of 126kV/63kA. The test results show that, it is accurate to control the making phase of the applied voltage, whether the closing is demanded at voltage peak or zero.展开更多
It is well accepted that lower hybrid current drive （LHCD） is the most efficient method for non-inductive current drive in fusion devices and the effect of the current drive is dependent on not only microwave power ...It is well accepted that lower hybrid current drive （LHCD） is the most efficient method for non-inductive current drive in fusion devices and the effect of the current drive is dependent on not only microwave power but also its grill phase shift. This paper presents a new kind of feedback control system for antenna phase difference in LHCD experiments. In this highspeed control system, a lot of new technologies and methods are incorporated. The results of the experiments show a very good agreement with the system design.展开更多
针对微特电机驱动控制系统中,双有源桥(dual active bridge,DAB)变换器在高频调制过程中易产生较大电流应力,导致器件温升高、寿命衰减及负载扰动下系统稳定性下降等问题,本文提出一种改进型双移相优化调制策略。该方法基于双有源桥拓扑...针对微特电机驱动控制系统中,双有源桥(dual active bridge,DAB)变换器在高频调制过程中易产生较大电流应力,导致器件温升高、寿命衰减及负载扰动下系统稳定性下降等问题,本文提出一种改进型双移相优化调制策略。该方法基于双有源桥拓扑,建立双移相调制下的功率传输模型与电流应力数学模型,采用拉格朗日乘数法求解最优移相比组合,并进一步推导多功率场景下的电流应力解析表达式;在控制器设计方面,引入电感电流内环补偿机制,提高系统对电机驱动过程中负载变化的动态响应能力。MATLAB/Simulink仿真结果表明,该方法在典型微特电机负载工况下能有效降低变换器的电流应力,缩短暂态响应时间,并改善输出电压纹波,对提升微特电机控制系统的稳态与暂态性能具有良好效果,为高效能电机驱动供电模块的优化设计提供理论依据。展开更多
In this paper, on the basis of the phase shifted controlled zero voltage switch (ZVS) full bridge converter with pulse width modulation (PWM), a novel zero voltage and zero current switch (ZVZCS) PWM converter u...In this paper, on the basis of the phase shifted controlled zero voltage switch (ZVS) full bridge converter with pulse width modulation (PWM), a novel zero voltage and zero current switch (ZVZCS) PWM converter using a simple auxiliary circuit was designed. The ZVZCS soft switch is achieved by the resonance among the resisting electromagnetic deflection capacitor, the capacitor of the simple auxiliary network and the leakage inductor of transformer. There are no dissipation devices of the saturation inductor and the auxiliary switch in the converter, meantime the capacitor of the auxiliary circuit is also used to clamp the voltage of the rectifier, and there is no additional clamped circuit. There is no big circulating current in the converter, all the active and passive devices work on the condition of the low current and voltage stress, and the proposed converter has wide load range and small duty loss.展开更多
在设计和研发大功率宽输出电压范围的双有源桥(dual active bridge,DAB)变换器时,传统的电流应力优化策略往往只关注移相比优化,忽略了电感量变化对电流应力的影响,这可能导致在大功率应用中电流应力超出理论预期,从而降低开关管的可靠...在设计和研发大功率宽输出电压范围的双有源桥(dual active bridge,DAB)变换器时,传统的电流应力优化策略往往只关注移相比优化,忽略了电感量变化对电流应力的影响,这可能导致在大功率应用中电流应力超出理论预期,从而降低开关管的可靠性。因此,在大功率应用场景下,为使变换器在全功率范围内获得最小电流应力,首先提出了考虑电感量随电流应力变化的动态关系,并基于此关系选择在恰当电感量下的优化三移相控制方法;其次,通过分析三移相控制并建立相应的数学模型,利用KKT(Karush-Kuhn-Tucker)条件寻求最优移相比组合,以实现电流应力优化;最后,搭建额定功率为100 kW的DAB变换器仿真模型及样机实验平台进行验证。实验结果表明,与传统三移相控制方法相比,所提方法在仿真和实验中都表现出较高的有效性,确保了变换器在整个运行过程中电流应力始终保持在理论预期范围内,保证了变换器在稳定运行时开关管的可靠性。展开更多
文摘The synthetic making test has been widely used in evaluating the break ability of high-voltage circuit breaker. However, the test research and application are still inadequate, especially in the condition of rated voltage. According to the realistic conditions of test stations in China, a control device based on pre-arcing current detection and phase control is proposed in this paper. A sample of the control device made up of DSP TMS320LF2407A is fabricated, in which the CPLD MAX7064 is used to transmit signals for EMC design. It can be applied in full voltage synthetic making test at a level of 126kV/63kA. The test results show that, it is accurate to control the making phase of the applied voltage, whether the closing is demanded at voltage peak or zero.
基金Meg-science Engineering Project of the Chinese Academy of Sciences
文摘It is well accepted that lower hybrid current drive （LHCD） is the most efficient method for non-inductive current drive in fusion devices and the effect of the current drive is dependent on not only microwave power but also its grill phase shift. This paper presents a new kind of feedback control system for antenna phase difference in LHCD experiments. In this highspeed control system, a lot of new technologies and methods are incorporated. The results of the experiments show a very good agreement with the system design.
文摘针对微特电机驱动控制系统中,双有源桥(dual active bridge,DAB)变换器在高频调制过程中易产生较大电流应力,导致器件温升高、寿命衰减及负载扰动下系统稳定性下降等问题,本文提出一种改进型双移相优化调制策略。该方法基于双有源桥拓扑,建立双移相调制下的功率传输模型与电流应力数学模型,采用拉格朗日乘数法求解最优移相比组合,并进一步推导多功率场景下的电流应力解析表达式;在控制器设计方面,引入电感电流内环补偿机制,提高系统对电机驱动过程中负载变化的动态响应能力。MATLAB/Simulink仿真结果表明,该方法在典型微特电机负载工况下能有效降低变换器的电流应力,缩短暂态响应时间,并改善输出电压纹波,对提升微特电机控制系统的稳态与暂态性能具有良好效果,为高效能电机驱动供电模块的优化设计提供理论依据。
文摘In this paper, on the basis of the phase shifted controlled zero voltage switch (ZVS) full bridge converter with pulse width modulation (PWM), a novel zero voltage and zero current switch (ZVZCS) PWM converter using a simple auxiliary circuit was designed. The ZVZCS soft switch is achieved by the resonance among the resisting electromagnetic deflection capacitor, the capacitor of the simple auxiliary network and the leakage inductor of transformer. There are no dissipation devices of the saturation inductor and the auxiliary switch in the converter, meantime the capacitor of the auxiliary circuit is also used to clamp the voltage of the rectifier, and there is no additional clamped circuit. There is no big circulating current in the converter, all the active and passive devices work on the condition of the low current and voltage stress, and the proposed converter has wide load range and small duty loss.
文摘在设计和研发大功率宽输出电压范围的双有源桥(dual active bridge,DAB)变换器时,传统的电流应力优化策略往往只关注移相比优化,忽略了电感量变化对电流应力的影响,这可能导致在大功率应用中电流应力超出理论预期,从而降低开关管的可靠性。因此,在大功率应用场景下,为使变换器在全功率范围内获得最小电流应力,首先提出了考虑电感量随电流应力变化的动态关系,并基于此关系选择在恰当电感量下的优化三移相控制方法;其次,通过分析三移相控制并建立相应的数学模型,利用KKT(Karush-Kuhn-Tucker)条件寻求最优移相比组合,以实现电流应力优化;最后,搭建额定功率为100 kW的DAB变换器仿真模型及样机实验平台进行验证。实验结果表明,与传统三移相控制方法相比,所提方法在仿真和实验中都表现出较高的有效性,确保了变换器在整个运行过程中电流应力始终保持在理论预期范围内,保证了变换器在稳定运行时开关管的可靠性。
