Pulse-like ground motions are capable of inflicting significant damage to structures. Efficient classification of pulse-like ground motion is of great importance when performing the seismic assessment in near-fault re...Pulse-like ground motions are capable of inflicting significant damage to structures. Efficient classification of pulse-like ground motion is of great importance when performing the seismic assessment in near-fault regions. In this study, a new method for identifying the velocity pulses is proposed, based on different trends of two parameters: the short-time energy and the short-time zero crossing rate of a ground motion record. A new pulse indicator, the relative energy zero ratio(REZR), is defined to qualitatively identify pulse-like features. The threshold for pulse-like ground motions is derived and compared with two other identification methods through statistical analysis. The proposed procedure not only shows good accuracy and efficiency when identifying pulse-like ground motions but also exhibits good performance for classifying records with high-frequency noise and discontinuous pulses. The REZR method does not require a waveform formula to express and fit the potential velocity pulses;it is a purely signal-based classification method. Finally, the proposed procedure is used to evaluate the contribution of pulse-like motions to the total input energy of a seismic record, which dramatically increases the seismic damage potential.展开更多
The way of neutral point to earth via full compensation arc suppression coil can solve the problem of residual current compensation in coal mine power network effectively. Based on the analysis on the grounding curren...The way of neutral point to earth via full compensation arc suppression coil can solve the problem of residual current compensation in coal mine power network effectively. Based on the analysis on the grounding current detection results of Xieqiao coal mine, the conclusion that harmonic component of grounding current is dominated by higher harmonics with complex harmonic sources in coal mine power network system was obtained. The influences of harmonic source type and fault point position on harmonic voltage and harmonic current were analyzed theoretically. The influences of earthed fault feeder detection result and the estimation errors of parameters to earth on residual current compensation were analyzed. A new thought of residual current prediction and the selections of model method and control method were proposed on this basis. The simulation results prove that harmonic amplitudes of zero sequence voltage and zero sequence current are determined by harmonic source type as well as fault point position in coal mine power network, and also prove that zero sequence voltage detection can avoid the unstable problem of coal mine power network system caused by undercompensation of capacitive current. Finally, the experimental device of full compensation arc suppression coil is introduced.展开更多
Using the neutral grounding method by the resistance in 110?kV system, it can limit the voltage sag and short circuit current when one-phase grounding fault occurred, but it will change the sequence of the network str...Using the neutral grounding method by the resistance in 110?kV system, it can limit the voltage sag and short circuit current when one-phase grounding fault occurred, but it will change the sequence of the network structure and parameters. This paper analyzes the size and distribution of zero sequence voltage and current when one-phase grounding fault occurred in the 110 kV resistance grounding system, and puts forward the grounding protection configuration setting principle of this system combining the power supplying characteristics of 110?kV distribution network. In a reforming substation as an example, the grounding protection of 110 kV lines and transformer have been set and calculated.展开更多
In this study, a total of 115,246 ground motions recorded during earthquakes of Moment magnitudes ranging from M_w 5.0 to M_w 9.0 are analyzed statistically. A total of 21 ground motion parameters characterising the r...In this study, a total of 115,246 ground motions recorded during earthquakes of Moment magnitudes ranging from M_w 5.0 to M_w 9.0 are analyzed statistically. A total of 21 ground motion parameters characterising the recorded acceleration time histories are used in the analysis. Classification of these parameters through statistical correlation is reported and a parameter called "distance from zero-amplitude axis," or d_(Z-A), is formulated in the principal component space. The ability for d_(Z-A) to rate the damage potentials of strong motion records is evaluated through correlation of d_(Z-A) with Japan Meteorological Agency(JMA) instrumental seismic intensities. This parameter can be used to rate damage potential of any strong motion record irrespective of the magnitude and location of the earthquake. It can also be used in selecting ground motion records of appropriate damage potential in seismic design and probabilistic analysis.展开更多
零序电流互感器(current transformer,CT)测量精度问题一直是限制配电网故障选线准确率的关键性问题,现有研究方法在理论层面已较为成熟,但在现场使用中受限于零序CT测量精度,耐过渡电阻能力往往不佳。灵活接地系统是一种新型接地方式,...零序电流互感器(current transformer,CT)测量精度问题一直是限制配电网故障选线准确率的关键性问题,现有研究方法在理论层面已较为成熟,但在现场使用中受限于零序CT测量精度,耐过渡电阻能力往往不佳。灵活接地系统是一种新型接地方式,系统感知永久性接地故障后,于中性点投入并联小电阻,使得配电网接地方式发生转变,从而导致同一电气信号量呈现两种完全不同的故障特征,故障信息量增加了一倍,综合利用两阶段故障特征有望突破现有故障选线装置性能极限,摆脱选线装置对零序CT测量精度的依赖。为此,该文首先分析了灵活接地系统不同阶段各电气量的故障特征,之后结合灵活接地系统特点提出了一种基于零序电流幅值比的高阻接地故障选线方法,最后通过合理设计选线算法,剔除误差较大数据,最大程度降低保护对零序CT测量精度的依赖。实时数字仿真系统(real time digital simulation system,RTDS)以及低压实验平台实验结果表明,该方法不受零序CT极性反接与相位测量误差影响,且无需故障信息间的横向比较,具有耐过渡电阻能力强、可靠性高、对零序CT测量精度要求低、易实现等优点。展开更多
Today the entire globe is shrouded in an inefficient three-phase system. There is however an efficient single-wire system. To use the single wire method, three phase systems can be converted to triple one wire systems.
The sounding data of a multi-channel parallel ground-based microwave radiometer （MWR） in Fuzhou station in July and August in 2016 were compared with the sounding data of a radiosonde in the same position in the sam...The sounding data of a multi-channel parallel ground-based microwave radiometer （MWR） in Fuzhou station in July and August in 2016 were compared with the sounding data of a radiosonde in the same position in the same period. The results showed that the correlations between the two types of temperature or humidity detected by the microwave radiometer and the radiosonde were significant at 0.05 level, indicating that the overall changing trends of temperature or humidity detected by the two devices were similar. The temperature detected by the microwave radiometer and the radiosonde decreased with the increase of height. The difference between the changes in the height of the zero layer detected by the micro- wave radiometer and the radiosonde was not significant, and their trends were basically the same.展开更多
基金Supported by:National Natural Science Foundation of China under Grant Nos.51378341,51427901 and 51678407National Key Research and Development Program under Grant No.2016YFC0701108
文摘Pulse-like ground motions are capable of inflicting significant damage to structures. Efficient classification of pulse-like ground motion is of great importance when performing the seismic assessment in near-fault regions. In this study, a new method for identifying the velocity pulses is proposed, based on different trends of two parameters: the short-time energy and the short-time zero crossing rate of a ground motion record. A new pulse indicator, the relative energy zero ratio(REZR), is defined to qualitatively identify pulse-like features. The threshold for pulse-like ground motions is derived and compared with two other identification methods through statistical analysis. The proposed procedure not only shows good accuracy and efficiency when identifying pulse-like ground motions but also exhibits good performance for classifying records with high-frequency noise and discontinuous pulses. The REZR method does not require a waveform formula to express and fit the potential velocity pulses;it is a purely signal-based classification method. Finally, the proposed procedure is used to evaluate the contribution of pulse-like motions to the total input energy of a seismic record, which dramatically increases the seismic damage potential.
基金The financial support from the National Natural Science Foundation of China (No. 51107143)
文摘The way of neutral point to earth via full compensation arc suppression coil can solve the problem of residual current compensation in coal mine power network effectively. Based on the analysis on the grounding current detection results of Xieqiao coal mine, the conclusion that harmonic component of grounding current is dominated by higher harmonics with complex harmonic sources in coal mine power network system was obtained. The influences of harmonic source type and fault point position on harmonic voltage and harmonic current were analyzed theoretically. The influences of earthed fault feeder detection result and the estimation errors of parameters to earth on residual current compensation were analyzed. A new thought of residual current prediction and the selections of model method and control method were proposed on this basis. The simulation results prove that harmonic amplitudes of zero sequence voltage and zero sequence current are determined by harmonic source type as well as fault point position in coal mine power network, and also prove that zero sequence voltage detection can avoid the unstable problem of coal mine power network system caused by undercompensation of capacitive current. Finally, the experimental device of full compensation arc suppression coil is introduced.
文摘Using the neutral grounding method by the resistance in 110?kV system, it can limit the voltage sag and short circuit current when one-phase grounding fault occurred, but it will change the sequence of the network structure and parameters. This paper analyzes the size and distribution of zero sequence voltage and current when one-phase grounding fault occurred in the 110 kV resistance grounding system, and puts forward the grounding protection configuration setting principle of this system combining the power supplying characteristics of 110?kV distribution network. In a reforming substation as an example, the grounding protection of 110 kV lines and transformer have been set and calculated.
文摘In this study, a total of 115,246 ground motions recorded during earthquakes of Moment magnitudes ranging from M_w 5.0 to M_w 9.0 are analyzed statistically. A total of 21 ground motion parameters characterising the recorded acceleration time histories are used in the analysis. Classification of these parameters through statistical correlation is reported and a parameter called "distance from zero-amplitude axis," or d_(Z-A), is formulated in the principal component space. The ability for d_(Z-A) to rate the damage potentials of strong motion records is evaluated through correlation of d_(Z-A) with Japan Meteorological Agency(JMA) instrumental seismic intensities. This parameter can be used to rate damage potential of any strong motion record irrespective of the magnitude and location of the earthquake. It can also be used in selecting ground motion records of appropriate damage potential in seismic design and probabilistic analysis.
文摘零序电流互感器(current transformer,CT)测量精度问题一直是限制配电网故障选线准确率的关键性问题,现有研究方法在理论层面已较为成熟,但在现场使用中受限于零序CT测量精度,耐过渡电阻能力往往不佳。灵活接地系统是一种新型接地方式,系统感知永久性接地故障后,于中性点投入并联小电阻,使得配电网接地方式发生转变,从而导致同一电气信号量呈现两种完全不同的故障特征,故障信息量增加了一倍,综合利用两阶段故障特征有望突破现有故障选线装置性能极限,摆脱选线装置对零序CT测量精度的依赖。为此,该文首先分析了灵活接地系统不同阶段各电气量的故障特征,之后结合灵活接地系统特点提出了一种基于零序电流幅值比的高阻接地故障选线方法,最后通过合理设计选线算法,剔除误差较大数据,最大程度降低保护对零序CT测量精度的依赖。实时数字仿真系统(real time digital simulation system,RTDS)以及低压实验平台实验结果表明,该方法不受零序CT极性反接与相位测量误差影响,且无需故障信息间的横向比较,具有耐过渡电阻能力强、可靠性高、对零序CT测量精度要求低、易实现等优点。
文摘Today the entire globe is shrouded in an inefficient three-phase system. There is however an efficient single-wire system. To use the single wire method, three phase systems can be converted to triple one wire systems.
文摘The sounding data of a multi-channel parallel ground-based microwave radiometer （MWR） in Fuzhou station in July and August in 2016 were compared with the sounding data of a radiosonde in the same position in the same period. The results showed that the correlations between the two types of temperature or humidity detected by the microwave radiometer and the radiosonde were significant at 0.05 level, indicating that the overall changing trends of temperature or humidity detected by the two devices were similar. The temperature detected by the microwave radiometer and the radiosonde decreased with the increase of height. The difference between the changes in the height of the zero layer detected by the micro- wave radiometer and the radiosonde was not significant, and their trends were basically the same.
